轴向位置的英文

• axial position

• "轴向"英文翻译    axial
• "位置"英文翻译    seat; place; location; site
• "刀盘的轴向位置" 英文翻译 :    cutter axial
• "轴向位置指示器" 英文翻译 :    axal position indicator
• "向位置" 英文翻译 :    u position; v position
• "轴向位移" 英文翻译 :    axial di lacement; axial displacement
• "轴向位移，保护" 英文翻译 :    axis disprotection
• "u向位置" 英文翻译 :    u position
• "背向位置" 英文翻译 :    trailing position
• "垂向位置" 英文翻译 :    vertical position
• "航向位置" 英文翻译 :    course position
• "横向位置" 英文翻译 :    horizontal position; lateral attitude
• "径向位置" 英文翻译 :    radial position
• "门横向位置" 英文翻译 :    gate lateral position
• "切向位置" 英文翻译 :    tangential position
• "弦向位置" 英文翻译 :    chordwise location; chordwise position
• "准向位置" 英文翻译 :    boresight location
• "纵向位置" 英文翻译 :    lengthwise position
• "侧斜轴向位移" 英文翻译 :    skew-induced rake
• "齿轮轴向位移" 英文翻译 :    gear axial di lacement; gear axial displacement
• "接头轴向位移" 英文翻译 :    joint axial deformation
• "小轮轴向位移" 英文翻译 :    pinion axial di lacement; pinion axial displacement
• "轴向位移压缸" 英文翻译 :    axial displacement cylinder
• "浮心垂向位置" 英文翻译 :    vertical location of center of buoyancy
• "浮心横向位置" 英文翻译 :    transverse location of center of buoyancy

• Axial position indicator
  轴向位置指示器
• On the basis of this solution , this paper gives the sound pressure spectrum densities of broad band and harmonic sources , and then discusses the characteristics of these sound fields respectively in detail
  在此解基础上，本文得到宽频源和简谐源的近场声压谱密度，指出此2种声源近声场各自的特点及源的旋转半径和轴向位置对声场结构的影响。
• The local nu of the no 2 baffle was studied , the results indicated that with the liquid flowing in the channel , the distance increase continuously , the local nu of the no 2 baffle fluctuated . from up to down , and from down to up
  本文在分析通道整体换热的基础上，还研究了2 #板的局部nu数的情况，实验结果表明，局部nu数随着轴向位置的增大呈先上升，再下降，然后再上升的趋势。
• Modal bode plot theory for diagnosing the rotor imbalance axial position and rotor imbalance type is presented based on advanced rotor dynamics theory and field balancing rotating machinery theory and comprehensive experience of field balancing steam - turbine generator set
  摘要基于转子动力学理论、汽轮发电机组轴系现场动平衡理论和工程实践经验，提出可直接判断轴系不平衡轴向位置及不平衡型式的振型波特曲线方法。
• Among different movement mode of moving mass , the influence of lateral displacement of the moving mass on the attitude motion of the re - entry vehicle is discussed , the effect of different moving mass ratio and axis position imposing on the attitude of the reentry vehicle is also studied
  本论文详细地分析了影响系统姿态的因素,研究了在不同的质量体运动形式下,活动质量体的横向偏移量、质量比、和轴向位置对姿态动力学响应的影响。
• This paper studies the application of inductively coupled plasma ( icp ) technology to the etching compound semiconductor insb - in film . by means of single probe and double probe , the ion density and electron temperature of chamber ( 30mm and 50mm in height respectively ) under varied process condition were diagnosed . the spatial distribution of the axial position of the two parameters and the varied curve that the two parameters varies with the power and air pressure are obtained
  利用单探针和双探针诊断30mm高反应室和50mm高反应室在各种工艺条件下的离子密度和电子温度，得到这两个参数在反应室轴向位置的空间分布、随功率和气压的变化曲线、顶盖接地和反应室体积对它们的影响，结果表明离子密度为10 ~ 8 10 ~ ( 10 ) cm ~ ( - 3 ) ，电子温度在4 10ev之间；当顶盖接地时，该处的等离子体密度明显大于不接地；在同样条件下， 50mm高反应室内的离子密度明显大于30mm高反应室。
• After the discussion of the algorithm of complexity parameters , lyapunov exponent and apen , the pressure fluctuation in fluidized beds is analyzed quantitatively . the effect of different operating conditions , such as variant gas superficial velocities , axial positions and static bed heights , is discussed
  在讨论复杂性参数、 lyapunov指数、近似熵的算法基础上，对流化床压力脉动进行定量分析，讨论了表观气速、轴向位置、静床高等不同操作条件对混沌特征参数的影响及其对应的动力学规律。