热温度的英文

• bolometric temperature

• "温度"英文翻译    temperature
• "暗红热温度" 英文翻译 :    dark red heat; low red heat
• "白热温度" 英文翻译 :    brightness temperature
• "赤热温度" 英文翻译 :    red heat temperature
• "地热温度" 英文翻译 :    geotemperature; geothermal temperature
• "地热温度；地温" 英文翻译 :    geotemperature
• "电热温度计" 英文翻译 :    thermelometer
• "废热温度" 英文翻译 :    heat-rejection temperature
• "过热温度" 英文翻译 :    overtemperature; super heating temperature; superheat temperature; superheating temperature; superheattemperature
• "红热温度" 英文翻译 :    red heat temperature
• "后热温度" 英文翻译 :    postheating temperature
• "加热温度" 英文翻译 :    heating temperature; heating-up temperature
• "绝热温度" 英文翻译 :    adiabatic temperature
• "均热温度" 英文翻译 :    soaking temperature
• "耐热温度" 英文翻译 :    heat-resistance temperature
• "预热温度" 英文翻译 :    preheat temperature; preheating temperature; preheattemperature
• "自热温度" 英文翻译 :    self-heating temperature
• "地热温度测量" 英文翻译 :    geothermometry
• "二次加热温度" 英文翻译 :    reheat temperature
• "高热温度状况" 英文翻译 :    hyperthermic temperature regime
• "过热温度调节" 英文翻译 :    superheat control
• "过热温度界限" 英文翻译 :    hyperpyrexial temperature limit
• "火焰绝热温度" 英文翻译 :    adiabatic flame
• "绝热温度变化" 英文翻译 :    adiabatic temperature change; adiabatictemperaturechange
• "绝热温度上升" 英文翻译 :    adiabativ temperature rise

• Compensation of temperature
  均温均热温度补偿
• Equalization of temperature
  均温均热温度补偿
• Dark red heat
  暗红热温度
• And it contains temperature sensor error alarm and other functions . it has one external alarm
  本控制器为单制热温度控制器，具有温控探头故障告警功能。
• The controller is a single heating controller , and it contains temperature sensor error alarm and other functions
  本控制器为单制热温度控制器，具有温控探头故障告警功能。
• The optimized experiments were used to explore the optimal hydrothermal conditions in order to prepare cu powders which have excellent properties . the optimal parameters of hydrothermal experiment as follows : the temperature is 240 , the time of reaction is 10h and the volume ratio of solution filling is 80 %
  将粒度均匀性和开始氧化温度作为衡量铜粉性能的指标,最终得到的最佳工艺参数为:水热温度为240 ,反应时间为10h ,溶液填充度为80 % 。
• Based on the predecessor ' s research , we focus on the concrete of large volume at basement inside high building . firstly , we have developed a software called 3d - efp , which have good practice in temperature predicting , secondly , we have aslo managed to get a whole set of scientific & advanced technology to monitor the temperature inside the concrete
  其次，在大体积砼水化热温度实时监测方面，我们经过多年的摸索与改进，研究出一整套科学的方法和先进的自动化技术，极大地促进了这类工程的“信息化施工” ，通过预测与实测的紧密配合，采取一系列有效的措施尽可能控制砼温度的变化，来达到防止温度裂缝产生的目的。
• We make a theoretical analysis of the experimental results and draw some conclusions as follows : the saturated temperature r290 - oil mixture is higher than that of pure r290 at a same pressure . the temperature difference , which is called superheat temperature of refrigerant - oil mixtures , increases as the oil concentration and the vapor quality are increased at a certain saturated pressure and pressure has negligible effect on the superheat temperature of the mixture . ( oil concentration is 0 . 43 ? - 5 . 28 ? )
  并根据实验结果进行理论计算，得出以下结论：天然制冷剂r290含油混合物的饱和温度高于相同压力下纯工质的饱和温度，这个温度差，也就是本文中提到的所谓制冷剂含油混合物的过热温度随混合物质量含气率、含油浓度的增加而增加，而饱和压力对过热温度的影响不大(含油率0 . 43 ? - 5 . 28 ? ) 。
• The conclusions reached are as follows : 1 . the saturated temperature of refrigerant - oil mixture is higher than that of pure refrigerant at a same pressure . the temperature difference , which is called superheat temperature of refrigerant - oil mixture , increases as the oil concentration and the vapor quality are increased at a certain saturated pressure and pressure has negligible effect on the superheat temperature of the mixture
  得出以下结论： 1 、相同压力下，制冷剂hc600a含油混合物的饱和温度高于纯工质的饱和温度，这个温度差，在就是文中称为的制冷剂含油混合物的过热温度，它随混合物质量含汽率、含油浓度的增加而增加，而饱和压力对过热温度的影响不大。
• Based on the analysis of the temperature test result of the landing rectangle aqueduct of caohe river for the emergency water supply project of the beijing - shijiazhuang section on the middle route of the south - to - north water diversion project , the temperature developing feature of the early - age hydration heat of the thin - wall concrete is described , and then the main effecting factors of the hydration heat temperature on the landing rectangle aqueduct and the control measures concerned are put forward herein
  摘要通过对南水北调中线京石段应急供水工程漕河渡槽段落地矩形渡槽温度测试结果的分析，阐述了薄壁混凝土早期水化热温度发展的特点，提出了影响落地矩形渡槽水化热温度的主要因素与控制措施。