受压区的英文

• compression zone
• compressive region
• compressive zone
• pressure zone

• "受"英文翻译    receive; accept
• "压"英文翻译    press; push down; hold down; ...
• "区"英文翻译    H region; H
• "受压区高度" 英文翻译 :    depth of compression zone; depth of neutral axis
• "界限受压区高度" 英文翻译 :    balanced depth of compression zone; balanced eccentricity
• "压区" 英文翻译 :    nip
• "受压" 英文翻译 :    in compression
• "变压区" 英文翻译 :    aliobar; allobar
• "常压区" 英文翻译 :    atmospheric area
• "冲压区" 英文翻译 :    stamping area
• "出压区" 英文翻译 :    outgoing nip
• "等压区" 英文翻译 :    constant cabin altitude state
• "低压区" 英文翻译 :    depression region; low pre ure area; low pressure area; low-pressure area; lowpre urearea; meiobar
• "负压区" 英文翻译 :    zone of negative pre ure; zone of negative pressure
• "高压区" 英文翻译 :    high area; high pressure area; high-pressure area; higher-pressure region; highpre urearea; zone of high pressure
• "恒压区" 英文翻译 :    areas of permanent pressure
• "挤压区" 英文翻译 :    crush zone
• "加压区" 英文翻译 :    pressor areas
• "减压区" 英文翻译 :    depressor area; reduced-pressure zone
• "降压区" 英文翻译 :    descent region; pressure-fall area
• "零压区" 英文翻译 :    region of no pressure
• "气压区" 英文翻译 :    baric area
• "升压区" 英文翻译 :    area of rising pressure
• "外压区" 英文翻译 :    external pressure region
• "增压区" 英文翻译 :    pressurized area; zone of elevated pressure

• Balanced depth of compression zone
  界限受压区高度
• Depth of compression zone
  受压区高度32
• When the ductility of steel bar is bad , the ductility of section will be bigger with the improvement of the ductility of steel bar
  钢筋延性较好，则构件截面延性随截面相对受压区高度的减小而增大；钢筋延性较差，则构件截面延性由钢筋延性控制。
• Then limiting load is decreased . ( 6 ) horizontal load can increase the coefficients of the modulation of moment when value of is little while decrease it when is large
  ( 6 )在中支座截面相对受压区高度较小时，有水平荷载的框架其弯矩调幅系数要大于只有竖向荷载的框架。
• The following conclusions are reached . ( 1 ) the relative height compressive zone of section or the axial force is bigger , the rotational capacity of the section is weaker
  得出了以下主要结论： ( 1 )截面相对受压区高度、截面所受轴力显著地影响预应力框架梁截面的延性。
• ( 5 ) horizontal load can increase the bearing ability of the section and the limiting load of the frame when value of is little . however , horizontal load can generates axial force and then deceases the ductility and bearing ability when is large
  ( 5 )在中支座截面相对受压区高度较小时，水平荷载在框架梁中产生轴力，提高截面的承载力，极限荷载也随之提高。
• The paper has concluded the fundamental principle of sticking reinforcement . that is to improve the ultimate flexural capacity of the original reinforced concrete beam through externally bonded with high - strength tension materials
  本文总结出粘贴加固的基本原理：通过粘贴高强的抗拉材料，进而使得受弯构件的受压区混凝土高度增加，从而提高原钢筋混凝土受弯构件的正截面承载力。
• ( 3 ) the relative height compressive zone of section greatly influences the redistribution of internal force of the prestressed frames . the total modulation of moment decreases according as the increase of relative height compressive zone of section
  随着中支座截面相对受压区高度的增大，次弯矩增大，次弯矩调幅增大，但荷载弯矩调幅以更大的幅度下降，导致总的弯矩调幅下降。
• 2 . the effect of frp reinforcement ratio on the ultimate moment of frp reinforced concrete beam is studied , the conclusion is that the ultimate moment increases with the increase of the reinforcement ratio for frp reinforced concrete beam in a certain range of reinforcement ratio
  结果表明，对纤维增强塑料筋混凝土梁，在配筋率的一定范围内，配筋率越大，受压区面积越大，极限抗弯承载力越高。
• 2 ) the secondary moment is an important factor on moment modulation . when is small , influence of the secondary moment on moment modulation is small . contrary , when is high , influence of the secondary moment is important
  （ 2 ）次弯矩的调幅作用非常明显，当相对受压区高度较小时，次弯矩对调幅的影响作用也小；反之，当相对受压区高度较大时，次弯矩对调幅的影响作用越大，有时，甚至起控制作用。