压区的英文

• nip

• "压"英文翻译    press; push down; hold down; ...
• "区"英文翻译    H region; H
• "变压区" 英文翻译 :    aliobar; allobar
• "常压区" 英文翻译 :    atmospheric area
• "冲压区" 英文翻译 :    stamping area
• "出压区" 英文翻译 :    outgoing nip
• "等压区" 英文翻译 :    constant cabin altitude state
• "低压区" 英文翻译 :    depression region; low pre ure area; low pressure area; low-pressure area; lowpre urearea; meiobar
• "负压区" 英文翻译 :    zone of negative pre ure; zone of negative pressure
• "高压区" 英文翻译 :    high area; high pressure area; high-pressure area; higher-pressure region; highpre urearea; zone of high pressure
• "恒压区" 英文翻译 :    areas of permanent pressure
• "挤压区" 英文翻译 :    crush zone
• "加压区" 英文翻译 :    pressor areas
• "减压区" 英文翻译 :    depressor area; reduced-pressure zone
• "降压区" 英文翻译 :    descent region; pressure-fall area
• "零压区" 英文翻译 :    region of no pressure
• "气压区" 英文翻译 :    baric area
• "升压区" 英文翻译 :    area of rising pressure
• "受压区" 英文翻译 :    compression zone; compressive region; compressive zone; pressure zone
• "外压区" 英文翻译 :    external pressure region
• "增压区" 英文翻译 :    pressurized area; zone of elevated pressure
• "正压区" 英文翻译 :    zone of positive pre ure; zone of positive pressure
• "高压区及低压区" 英文翻译 :    high and low pressure area
• "压区挡板，压区防护板" 英文翻译 :    niguard
• "岸墩承压区" 英文翻译 :    abutment zone

• Balanced depth of compression zone
  界限受压区高度
• Depth of compression zone
  受压区高度32
• The gas drainage technique with short boreholes in stress reduced area for mining face with outburst hazard
  高突工作面卸压区浅孔抽放技术
• Research on technology of draining methane off shallow borholes in a stress - relaxation area of working face
  工作面卸压区浅孔瓦斯抽放技术研究
• When the ductility of steel bar is bad , the ductility of section will be bigger with the improvement of the ductility of steel bar
  钢筋延性较好，则构件截面延性随截面相对受压区高度的减小而增大；钢筋延性较差，则构件截面延性由钢筋延性控制。
• According to simulated results , we can get the range of side pressure relief at the mining face , at the upper coal or the lower coal under the peculiar condition
  根据模拟结果得出：特定开采条件下，上部或下部不同煤层采煤工作面侧向却压区范围。
• 9 pieces of rc test beams were fabricated , the fbg sensors and strain gauges were mounted in the tensile steel , compress concrete and cfrp of the tested beams
  制备9根rc试验梁,将fbg传感器与电阻应变片同时预置于实验梁内(受拉钢筋、压区混凝土及碳纤维复合材料中) 。
• Then limiting load is decreased . ( 6 ) horizontal load can increase the coefficients of the modulation of moment when value of is little while decrease it when is large
  ( 6 )在中支座截面相对受压区高度较小时，有水平荷载的框架其弯矩调幅系数要大于只有竖向荷载的框架。
• The following conclusions are reached . ( 1 ) the relative height compressive zone of section or the axial force is bigger , the rotational capacity of the section is weaker
  得出了以下主要结论： ( 1 )截面相对受压区高度、截面所受轴力显著地影响预应力框架梁截面的延性。
• This model transacts and calculates pull and press section of reinforcement concrete by different methods : the reinforcing steel bar element model is adopted at pull section and the reinforced concrete enblock model is adopted at press section
  该模型用不同方法处理计算钢筋混凝土拉区和压区：拉区钢筋采用杆件单元模型，压区钢筋混凝土则采用整体式模型。