保压压力的英文

• dwell pressure
• dwell presure

• "保压"英文翻译    pressurize; pressure maintai ...
• "压力"英文翻译    pressure; tension
• "背压压力计" 英文翻译 :    backpressure manometer; back-pressure manometre; backbone pressure manometer; backbone pressure manometre
• "差压压力表" 英文翻译 :    differential pressure gauge; differential pressure manometer; differential pressure meter; differential(pressure)gauge; differentialgauge
• "低压压力表" 英文翻译 :    low pressure gauge
• "低压压力柜" 英文翻译 :    low pressure tank
• "高压压力表" 英文翻译 :    blowout-back pre ure gauge; blowout-back pressure gauge; high pressure gauge; high-pressure manometer
• "恒压压力焊" 英文翻译 :    constant-pressure pressure welding
• "挤压压力" 英文翻译 :    extrusion pressure
• "挤压压力机" 英文翻译 :    squeezing press
• "精压压力机" 英文翻译 :    coining press
• "热压压力" 英文翻译 :    hot pressing pressure
• "升压压力" 英文翻译 :    boost pressure
• "升压压力表" 英文翻译 :    boost garge; boost gauge; boost manometer
• "液压压力盒" 英文翻译 :    hydraulic cell
• "再压压力" 英文翻译 :    recompression pressure
• "增压压力" 英文翻译 :    backing pressure; boost pressure; boost presure; loading pressure; pressurization pressure; supercharge pressure; supercharged pressure
• "增压压力比" 英文翻译 :    boost pressure ratio
• "增压压力表" 英文翻译 :    boost pre ure gauge; boost pressure gage; boost pressure gauge
• "保压" 英文翻译 :    pressurize; pressure maintaining◇保压阀 pressure retaining valve; 保压时间 dwell time (压铸)
• "冲压压力恢复" 英文翻译 :    ram pressure recovery
• "高压压力梯度" 英文翻译 :    upnormal pressure gradient
• "固定挤压压力" 英文翻译 :    stationary extrusion pressure
• "静液压压力计" 英文翻译 :    hydrostatic gauge
• "空气增压压力" 英文翻译 :    air charging pressure

• Improve injection speed and holding time or pressure
  改善注塑速度和保压压力或时间
• Increase dose , holding time and holding pressure
  增加料量,保压时间和保压压力
• Reduce injection speed and holding pressure
  减小注塑速度和保压压力
• Raise value and time of holding pressure
  提高保压压力和时间
• Raise holding time and pressure
  增加保压时间和保压压力
• Check holding pressure
  检查保压压力
• The green body of high quality could be obtained at injection molding temperature from 160c to 180 c , injection molding pressure from loompa to 120mpa , keeping pressure from 40mpa to sompa , mold - temperature 32c , cooled from 2 min to 4 min
  注射温度为160 180 ，注射压力为100 120mpa 、保压压力为40 50mpa 、模具温度为32 、冷却时间为2 4min注射成型后，注射坯的质量较好。