静态工作点的英文

发音:

"静态工作点"怎么读用"静态工作点"造句

英文翻译手机版

quiescent operating point
quiescent operating-point
quiescent operation point
quiescent point

"静态"英文翻译 static state; quiescent cond ...
"工作"英文翻译 work; operation; working; op ...
"点"英文翻译 drop
"静态工作" 英文翻译 : quiescent operation; static work
"工作点" 英文翻译 : action spot; operating piont; operating point; work station; working point
"静态工足" 英文翻译 : quiescent point
"静态工厂方法" 英文翻译 : static factory method
"动态工作" 英文翻译 : dynamic duty; dynamicduty
"双稳态工作" 英文翻译 : bistable operation
"准稳态工作" 英文翻译 : quasi steady operation; quasi-steady operation
"工常工作点" 英文翻译 : normal working point
"工作点标高" 英文翻译 : working point elevation
"工作点评定" 英文翻译 : job pointing rating
"工作点稳定" 英文翻译 : stabilization of operating point
"开始工作点" 英文翻译 : cut in point; cut-in point
"平衡工作点" 英文翻译 : matching point
"设计工作点" 英文翻译 : design duty point; projected working point
"正常工作点" 英文翻译 : normal working point
"最佳工作点" 英文翻译 : best operating point
"动态工作场所" 英文翻译 : dynamic workplaces
"临界状态工作" 英文翻译 : critical operation
"脉冲状态工作" 英文翻译 : pulse operation; pulsed operation
"发动机工作点" 英文翻译 : engine operating point
"工作点寄存器" 英文翻译 : work point register
"压缩器工作点" 英文翻译 : compressor operating point

例句与用法

Also , cathode bias circuits ( with bypass capacitors ) are not very successful , since for dc bias purposes , the cathode resistor presents a high dc resistance equivalent at the anode , and the quiescent point is not very stable
而且，阴极偏压电路（带旁路电容）也很难成功，因为直流偏压的原因，阴极电阻在屏级上表现出很高的等效直流电阻，这样静态工作点很难得以稳定。
In the fifth chapter , a new fully differential operational amplifier with voltage and current - mode negative feedback has been proposed , which can stabilize its quiescent operation point , using the characteristic of mos transistors which operate in the triode region acting as active variable resistor , a fully differential fourth - order chebyshev low - pass filter with tunable frequency and bessel low - pass filter with accurate group delay based on r - mosfet - c and operational amplifier has been designed
第五章：提出了一种新的既具有电压共模负反馈又同时具有电流共模负反馈的全差分运算放大器电路，能较好地稳定电路的静态工作点，并应用mos管工作在线性区可作有源可变电阻用的特性设计得到了截止频率可连续调节的高性能r - mosfet - c 、运放结构切比雪夫( chebyshev )和精确群时延值贝塞尔( bessel )低通滤波器。
In chapter 4 , the principle drawing of the system is presented after adding a constant - pressure - drop valve . the operating principal of the valve is briefly introduced . the static mathematical model is built up and study is carried out by means of simulation under the circumstance of matlab , then the static working point is obtained
对定差减压阀作了简要的介绍，根据系统工作原理图建立静态数学模型进行仿真研究，由仿真结果分析系统静态工作特性，得到静态工作点；然后，建立系统动态模型，对其动态特性进行非线性仿真研究，并就环境因素变化对系统工作特性的影响作了详细分析。
Basic structural parameters of magnetic bearings are analyzed and principles of selecting these parameters are introduced . basic characters of magnetic bearings are analyzed , including static working point , the largest magnetic force and power losses etc . assigning maximal magnetic force as objective function , the optimal design of radial magnetic bearing in magnetic levitated hard disk drive is completed , and the results of optimal design are presented
对磁力轴承的基本结构参数进行了分析，阐述了这些参数的选用原则；对磁力轴承的几个基本特性进行了分析，包括静态工作点、最大承载力、功率损耗等；以最大承载力为目标对磁悬浮硬盘的径向轴承进行了结构优化设计，并对优化结果进行了分析。
The other is the design of amplifier with constant trans - conductance ( gm ) rail - to - rail input stage . when common mode input voltage changes , it provides nearly constant - gm independent of input transistor operating region ( strong , moderate or weak inversion ) , and the quiet nods of the circuit for current addition and the output stage keep unchanged
当输入共模电压变化时,不管它的输入mos差分对管处于强反型区还是弱反型区,输入级的跨度保持不变,而且输入级后面的电流加法电路和输出级的静态工作点也不会随之改变。
In chapter 2 , the operating principal of the hydraulic loading subsystem ' s of the tm is briefly introduced and the open - loop mathematical model is built up and study is carried out by means of simulation under the circumstance of matlab . the static working points are obtained and lay foundation for the proceeding dynamic simulation
第二章，简要介绍试验机液压加载子系统的工作原理，建立液压系统开环数学模型进行仿真研究，并根据仿真结果分析静态工作特性，得到静态工作点，为动态模型的非线性仿真奠定基础。