进样口的英文

• injection port

• "进"英文翻译    advance; move forward; move ...
• "样"英文翻译    appearance; shape
• "口"英文翻译    mouth
• "玻璃进样口" 英文翻译 :    glass introduction port
• "进样" 英文翻译 :    sample injection; sample introduction; sampling
• "取样口" 英文翻译 :    sample connection; thief hatch
• "试样口" 英文翻译 :    probe inlet
• "异样口味" 英文翻译 :    foreign taste
• "疱疹样口炎" 英文翻译 :    stomatitis herpetiformis
• "阀进样" 英文翻译 :    valve injection
• "进样泵" 英文翻译 :    sampling pump; samplingpump
• "进样阀" 英文翻译 :    admission valve; injection valve; introduction valve; sample valve; sampling valve
• "进样量" 英文翻译 :    sample size
• "进样器" 英文翻译 :    sample injector; sampler
• "玻璃进样球" 英文翻译 :    glass sampling bulb; glass-sampling bulb
• "不分流进样" 英文翻译 :    splitless injection; splitless sampling
• "场放大进样" 英文翻译 :    electrical field magnified injection
• "抽空进样" 英文翻译 :    injection vacuum; injection, vacuum
• "单针进样" 英文翻译 :    single run
• "电动进样" 英文翻译 :    electrokinetic injection; hydrodynamic injection
• "电迁移进样" 英文翻译 :    electromigration injection; electrophoretic injection; injection, electromigration
• "动力进样" 英文翻译 :    hydrodynamic injection
• "二次进样" 英文翻译 :    sub sampling
• "分流进样" 英文翻译 :    split injection; split sampling; split stream sampling
• "分批进样" 英文翻译 :    batch inlet; batch sampling

• If using a split / splitless inlet , check that the purge valve is on
  如果使用分流/不分流进样口，检查分流阀是否打开。
• Clean the injector port , replace critical injection port seals , replace injection port liners , and change septa as needed
  清洗进样口，如有必要，更换密封垫，衬管，隔垫。
• Adding an optional heating attachment enables you to maintain preheated samples at temperatures up to 80 c . this allows you to fill samples which are highly viscous at ambient temperature
  选配一台进样口加热装置，则可保持预热样品的温度在80 c ，这使得高粘度样品在室温条件下就能顺利进样。
• Under this condition , the linear range , the limits of detection , the recoveries , the relative standard deviations of the method to every component have been carried on
  进样口温度220 ，检测器温度250 。在此条件下，对各组分进行了方法的线性范围及检测限，方法的准确度，方法的精密度测定。
• The electric field distribution at the cross is simulated and analyzing using the soft of ansys5 . 7 . then the electrophoretic method has been optimized . the electrophoresis and the volume of injection have been significantly controlled using this method
  设计了微通道电泳芯片的电泳操作方法，并用有限元分析软件对在进样和分离条件下，进样口处的电场强度分布进行了模拟分析，在此基础上对电泳操作方法进行了优化，实现了进样量和电泳过程的有效控制； 6