负载电阻的英文

• load resistance
• loading resistance
• loading resistor
• pull up resistor
• pull-uresistor

• "负载"英文翻译    load
• "电阻"英文翻译    resistance; electric resista ...
• "负载电阻器" 英文翻译 :    loading resistor; pull-up resistor
• "假负载电阻" 英文翻译 :    dummy resistance
• "板极负载电阻" 英文翻译 :    plate load resistance
• "出端负载电阻" 英文翻译 :    output load resistance
• "仿真负载电阻" 英文翻译 :    dummy load resistance
• "级间负载电阻" 英文翻译 :    interstage load resistance
• "假负载电阻器" 英文翻译 :    dummy resistor
• "匹配负载电阻" 英文翻译 :    matched load resistance
• "输出负载电阻" 英文翻译 :    output load resistance; output load resistor
• "阳极负载电阻" 英文翻译 :    anode load resistor
• "最佳负载电阻" 英文翻译 :    optimum load resistance
• "负载电阻光电管" 英文翻译 :    load-resistance photocell
• "输出负载电阻器" 英文翻译 :    output load resistor
• "水冷式负载电阻" 英文翻译 :    water-cooled load resistance
• "限制负载电阻器" 英文翻译 :    load limiting resistor
• "负载电机" 英文翻译 :    load motor
• "负载电缆" 英文翻译 :    loaded cable
• "负载电流" 英文翻译 :    load current; load-current
• "负载电流表" 英文翻译 :    load-current meter
• "负载电流计" 英文翻译 :    load-current meter
• "负载电路" 英文翻译 :    load circuit
• "负载电门" 英文翻译 :    load switch
• "负载电容" 英文翻译 :    load capacitor

• Analog quantity output : dc 420 ma load resistance 750
  模拟量输出dc 4ma20ma负载电阻750
• Power supply : 24vdc10 load resistance : 1100max power supply below 360v
  负载电阻： 1100ma x在360v电源条件下
• In chart , ups is power source , lr is load resistance , tx is intelligent transmitter
  图中， ups为电源， lr为负载电阻， tx为智能变送器。
• Measured at applied forward current of 10ma , reverse current 1 . 0ma , reverse voltage of 6 . 0 voltage and rl = 100 ohms
  测试条件:提供10毫安顺向电? , 6伏等逆向偏压与100欧姆负载电阻,并于逆向电?回覆至1毫时?得的时间
• This type of configuration requires a much higher power supply voltage , since the power supplied to the output stage is supplied through this load resistor
  这种结构需要一个很高地电源高压，因为输出级的高压需要通过负载电阻。
• The d . c . resistance of each phase is also checked against the calculated resistance value for the stator and for balanced resistance between each phase
  每个相位的直流电阻也经过与定子的设计负载电阻值进行核对，以确认能够在每个相位之间进行平衡。
• Combined with researches on propagation characteristics , the micro - current sensor for on - line pd monitoring is developed and the effects of coil number , stray capacitance and loading resistance on pass - band and sensitivity are also studied
  同时，结合传播特性，研究了局部放电在线监测宽带微电流传感器，并就线圈匝数、杂散电容和负载电阻等对传感器通频带、灵敏度等性能参数的影响进行了分析。
• The system parameters are developed at the same time , and some universal conclusions on the theoretical analysis of pll are reached . then , we have carried on analysis and research to the theory of differential delay ring voltage controlled oscillator ( vco ) . on this basis , a improved differential delay ring vco with more efficient loads is described . this circuit has been designed and implemented in 0 . 35 m cmos technology
  本文还对差分延迟结构环形压控振荡器电路进行了深入的分析与研究,并提出了一种基于高质量电阻电路的主从差分延迟结构环形压控振荡器,其采用了一种新型的主从差分延迟结构,并用一个更有效、更稳定的负载电阻电路结构来替代vco设计常使用的单个mos管电阻结构,使其系统稳定性有了相应提高。
• The conventional connection circuit as the figure shows for two - wired transmitter : handhold terminal palm computer and external communication interface or mainframe communication circuit cannot directly bridges in the ends of power source . but may either meet on field ends a and b or meet on the ends of load resistance b and c . in the above - mentioned case , the circuit are supplied by power source
  对两线制变送器来说，传统的连接电路如图所示：手持终端掌上电脑和外接通讯接口或主机通讯电路不能直接跨接在电源两端，但既可接于现场两端a ， b上，也可接在负载电阻两端b ， c ,两种情况下，电路都要通过电源来供电, hart规范允许负载电阻为2301100 。
• A voltage regulator mainly composed of a comparator is added to the main conversion circuit to stabilize the output voltage . using tspice simulation software , it is obtained that the output voltage of the converter with this regulator has a reduced ripple of less than 0 . 8 % and almost has nothing to do with the varied load resistance of more than 800
  为了稳定输出电压，在变换器主电路的基础上增加了主要由比较器构成的稳压环节，通过使用tspice对其模拟、优化设计后，得到的输出电压纹波小于0 . 8 ，并且在负载电阻? 800时，输出电压基本不随负载电阻阻值的变化而变化。

• 负载电阻的日语：ロードていこう ロード抵抗 ふかていこう ロードレジスタンス