调节螺丝的英文

• adjustable pile head
• adjustable screw
• adjusting screw、regulating screw ajustar rosca
• governing screw
• temper screw

• "调节"英文翻译    regulate; adjust; monitor; m ...
• "螺丝"英文翻译    screw
• "耕深调节螺丝" 英文翻译 :    depth regulating screw
• "零点调节螺丝" 英文翻译 :    zero point adjustment screw
• "模高调节螺丝" 英文翻译 :    die height adjustment screw
• "墨斗调节螺丝" 英文翻译 :    duct adjusting screw
• "牙叉调节螺丝" 英文翻译 :    feed forked connection adjusting screw
• "油压调节螺丝" 英文翻译 :    oil-pre ure adjusting screw; oil-pressure adjusting screw
• "力矩调节螺丝起子" 英文翻译 :    toque control driver
• "油压的调节螺丝" 英文翻译 :    oil-pressure adjusting screw
• "纸堆高度调节螺丝" 英文翻译 :    pile height adjusting screw
• "固定[定位]螺丝，弹簧调节螺丝。" 英文翻译 :    set screw
• "（封罐机）卷边输调节螺丝" 英文翻译 :    adjusting worm screw
• "三节螺丝" 英文翻译 :    feed forked connection hinge screw
• "三节螺丝帽" 英文翻译 :    feed forked connection hinge screw nut
• "调节螺钉, 调节螺旋" 英文翻译 :    adjusting screw
• "调节螺钉" 英文翻译 :    adjusting screw; governing screw; quarter screw; regulating screw; regulator screw; set screw; tuner screw; tuning screw
• "调节螺杆" 英文翻译 :    adjusting screw rod; adjusting screw(rod); temper screw
• "调节螺帽" 英文翻译 :    rating nut; regulating nut
• "调节螺母" 英文翻译 :    adjusting nut ajustar tuerco; adjusting screw nut; adjustment nut; rating nut; regulating nut; setting nut
• "调节螺栓" 英文翻译 :    adjustable bolt; adjuster bolt; adjusting bolt ajustar tornillo
• "调节螺套" 英文翻译 :    adjusting bolt adjusting screw
• "调节螺旋" 英文翻译 :    adjustable screw; adjusting color screw; adjusting screw
• "阀调节螺钉" 英文翻译 :    valve adjustment screw
• "链调节螺钉" 英文翻译 :    chain adjusting screw

• To readjust - loosen lock nut on the adjusting screw
  重新调节：松开调节螺丝上的锁定螺母。
• Adjusting screws are used to set the switching point whilst under pressure
  调节螺丝用来确定压力的开关点。
• Remove compression from spring by turning adjusting screw ( 1 ) counterclockwise
  通过反时针方向旋转调节螺丝( 1 )从弹簧上拆卸压缩件。
• The switching point is set using adjusting screws , and the switching status is indicated by an led
  开关点可通过调节螺丝设定，并通过一个led显示其状态。
• To replace seat / stem module shut off supply , loosen locknut and back off adjusting screw
  要更换阀座/阀杆模块，先关闭供应管道，松开锁紧螺母，退出调节螺丝。
• To increase the reduced pressure , turn the adjusting screw clockwise - opposite to decrease the reduced pressure
  增加减少的压力，顺时针方向旋转调节螺丝；相反则是减少减少的压力。
• To be individually adjusted at any time , and the integrated leds provide information about the switching status
  调节螺丝可以在任意时间个别地调节开关点。集成的led则提供了开关状态的信息。
• To replace seat disc or diaphragm loosen locknut ( 51 ) and back off adjusting screw ( 53 ) , remove four bonnet screws ( 24 ) and lift off cage ( 3 ) with spring ( 729 ) and washer ( 61 )
  要更换阀座阀瓣或隔膜，则松开锁紧螺母( 51 )并退出调节螺丝( 53 ) ，拆卸四个阀盖螺丝（ 24 ）并将带着弹簧( 729 )和垫圈( 61 )的笼( 3 ) 。
• The main reason is as follows : dust in lifting rail is not removed clean ; lifting rail is not at a level ; the installation of low locator is not correct ; regulate screw in lifting wheel regulates too high
  趟动门钰感觉不顾滑，主要原因有：吊轨里的灰尘没清除干净吊轨不够水平下定位安装不准确和吊轮调节螺丝调节过高造成。
• Check and adjust ( as needed ) valve clearance to the same specifications on nos . 2 , 4 and 6 exhaust and nos . 3 , 5 , and 6 intake valves . tighten valve adjusting screw locknut to 27 n ? m ( 20 lb - ft )
  检查并视需要将气门间隙调节到与2 、 4 、 6号排气阀以及3 、 5 、 6号进气阀相同的规格。将气门调节螺丝防松螺母拧紧至27牛顿?米（ 20磅- ? ） 。