调节手柄的英文

• adjusting handle
• regulating handle

• "调节"英文翻译    regulate; adjust; monitor; m ...
• "功率调节手柄" 英文翻译 :    power regulating handle
• "进刀调节手柄" 英文翻译 :    feed regulating lever
• "匹配调节手柄" 英文翻译 :    matching crank
• "气体调节手柄" 英文翻译 :    gas regulating handle
• "燃油调节手柄" 英文翻译 :    fuel regulating handle
• "速度调节手柄" 英文翻译 :    speed controller
• "位置调节手柄" 英文翻译 :    position control lever
• "行程调节手柄" 英文翻译 :    stroke regulating handle
• "牵引力调节手柄" 英文翻译 :    draught lever
• "入土深度调节手柄" 英文翻译 :    depth control handle; depth crank
• "索引力调节手柄" 英文翻译 :    draft control lever
• "提升杆调节手柄" 英文翻译 :    leveling handle
• "喂入器调节手柄" 英文翻译 :    feeder adjusting crank
• "振动速率调节手柄" 英文翻译 :    handle for regulating vibration speed
• "座舱空压调节手柄" 英文翻译 :    cabin air pressure control lever
• "座位高度调节手柄" 英文翻译 :    seat height adjusting lever
• "草捆压实密度调节手柄" 英文翻译 :    bale density control handle
• "燃油喷射器正时调节手柄" 英文翻译 :    fuel injection timing handle
• "座舱空气压力调节手柄" 英文翻译 :    cabin air pressure control lever
• "座椅前后位置调节手柄" 英文翻译 :    adjusting handle，longitudinal position ofseat
• "调速器转速调节手柄用伺服马达" 英文翻译 :    servo motor for governor speed-setting lever
• "牵引力调节手柄, 牵引力控制杆" 英文翻译 :    draught lever
• "调节手轮" 英文翻译 :    adjusting hand wheel; adjusting handle; control hand wheel
• "金融调节手段" 英文翻译 :    monetary device

• The regulating handle is fitted with a fine speed adjust knob and a latch
  调节手柄配有一个细的速度调整旋扭一个锁销。
• The regulating handle consists of manoeuvring valve pos . no . 01 and handle mechanism
  调节手柄由操纵阀01和手柄机构组成。
• Because the output pressure signal of the manoeuvring valve ( pos . no . 01 - ) corresponding to the regulating handle position determines the output rate of the p . g . governor through the 3 - way valve ( pos . no . 29 , lower frame )
  因为操纵阀01 -相应调节手柄位置的输出压力信号决定调速器输出比率通过三通阀29 ，下位。
• After completion of the starting operation , engineer can drive the main engine at the speed as he desires by moving the regulating handle in the range between the min . fuel position and the max . fuel position
  在启动操作完成后，轮机员可以驱动主机到他想要的转速通过移动调节手柄在最小燃油位置和最大燃油位置之间范围内。
• After the normal air - running , engineer must move the regulating handle to the position corresponding to the pressure which has been set by the pressure reducing valve ( pos . no . 28 ) when the speed of the main engine is more than the air cut speed
  在正常的空气运转后，轮机员必须移动调节手柄到相应的压力的位置，其压力已由压力减压阀28设定，当主机的转速已经高于空气切断转速。