设定温度的英文

• design temperature
• setting temperature

• "设"英文翻译    x
• "定"英文翻译    galipidine
• "温度"英文翻译    temperature
• "燃料元件最高设定温度" 英文翻译 :    maximum assessed fuel element temperature
• "定温箱温度" 英文翻译 :    incubative temperature
• "额定温度" 英文翻译 :    rated temperature
• "给定温度值" 英文翻译 :    junction temoverride
• "规定温度" 英文翻译 :    rated temperature; set point of temperature; set temperature; specified temperature; stipulated temperature
• "恒定温度" 英文翻译 :    constancy of temperature
• "假定温度" 英文翻译 :    fictive temperature
• "检定温度" 英文翻译 :    proving temperature
• "稳定温度" 英文翻译 :    equilibrium temperature; immobile temperature; steady temperature
• "限定温度" 英文翻译 :    limiting temperature
• "选定温度" 英文翻译 :    selected temperature
• "一定温度" 英文翻译 :    uniform temperature
• "预定温度" 英文翻译 :    preset temperature
• "炉子额定温度" 英文翻译 :    furnace rated temperature
• "预定温度控制" 英文翻译 :    preselected temperature control
• "在规定温度下" 英文翻译 :    g/cm
• "准稳定温度场" 英文翻译 :    quasi-stationary temperature field
• "最小额定温度" 英文翻译 :    minimum temperature rating
• "测定温度之单位" 英文翻译 :    degree-day
• "导线最大额定温度" 英文翻译 :    maximum rated conductor temperature
• "额定温度,额定电压" 英文翻译 :    rated temperature, voltage
• "料筒温度设定" 英文翻译 :    cylinder temperature setting

• Temperature difference and setting temperature
  温差”和“设定温度
• When displaying current temperature , the temperature is between setting temperature
  在显示温度状态，温度介于“设定温度
• Min setting temperature
  最低设定温度
• Max setting temperature
  最高设定温度
• Temperature difference , and it stops heating when the temperature is over setting temperature
  温差”时启动制热，一直到温度高于“设定温度
• Here the nixietube shows the temperature of setting , then use the key
  指示灯亮，进入温度设置状态，这时数码显示器上显示的温度即为设定温度，然后用
• Temperature difference , and it stops refrigerating when the temperature is under setting temperature
  温差”时启动制冷，一直到温度低于“设定温度
• When temperature controller is properly installed , set the point at the maintenance temperature of media
  防爆温控器正确安装后，应将其设定温度调整在介质维持温度上。
• Controlling temperature can set according to temperature set and temperature difference . if set temp is 20
  温度控制根据“设定温度”和“温差”两个参数进行，假设“设定温度”为
• The program may prevent the mixer from resuming activity until the temperature has dropped back to the established point
  程序直到温度返回到允许的设定温度后，才能恢复搅拌过程。