绕组电阻的英文

• winding resistance
• wire-wound resistor

• "绕组"英文翻译    winding
• "电阻"英文翻译    resistance; electric resista ...
• "波绕组电机" 英文翻译 :    wave winding machine
• "多绕组电机" 英文翻译 :    multi-winding machine
• "多绕组电枢" 英文翻译 :    multiple-wound armature
• "副绕组电线" 英文翻译 :    secondary cable
• "绕组电感" 英文翻译 :    winding inductance
• "绕组电流" 英文翻译 :    winding current
• "绕组电压" 英文翻译 :    winding voltage
• "双绕组电枢" 英文翻译 :    double winding armature; doublewinding armature
• "原绕组电压" 英文翻译 :    primary winding voltage
• "扁线绕组电枢" 英文翻译 :    strip-wound armature
• "波状绕组电机" 英文翻译 :    wave winding machine
• "二次绕组电感" 英文翻译 :    secondary inductance; secondaryinductance
• "一次绕组电感" 英文翻译 :    primary inductance
• "一次绕组电压" 英文翻译 :    primary winding voltage
• "电枢绕组电枢绕法" 英文翻译 :    armature winding
• "对数绕组电动机" 英文翻译 :    logarithm winding motor
• "多重绕组电动机" 英文翻译 :    multiple winding motor
• "分段励磁绕组电机" 英文翻译 :    tap-field motor
• "双励磁绕组电动机" 英文翻译 :    dual-field motor
• "转子绕组电动机" 英文翻译 :    wound-rotor motor
• "高电阻绕组" 英文翻译 :    high-resistance wind
• "混合绕组电流互感器" 英文翻译 :    compound-wound current transformer
• "上层绕组电机槽中的" 英文翻译 :    top slot layer

• Fast resistance measuring of low voltage winding of large transformer
  主变压器低压绕组电阻的快速测量
• Study of the measuring methods of zero - time constant for coil - block in transformers
  变压器绕组电阻零时间常数测量方法的研究
• Measurement of the winding resistance of an a . c . machine during operation at alternating voltage
  交流电机在交流电压运行期间绕组电阻的测量
• Calculation of armature resistance and inductance for linear generator used in magnetic levitation vehicle
  磁悬浮列车中直线发电机电枢绕组电阻和电感的计算
• However , the result of the simulation , in which all the parameters are kept constant except the primary and secondary inductance , is that 3 % higher conversion efficiency can be achieved in ccm than in dcm
  但对输出功率和绕组电阻相同时逆变电路仿真结果表明， ccm的效率比dcm提高了三个百分点；试验结果说明尽管ccm的绕组电阻比dcm的大，变换器效率仍提高了1 . 5 。
• Then a thorough analysis to the bias - magnetic of ppfc is made . the retraining effects of the main parameters ( include clamping capacitance c , output filter inductor lf , load r , the leakage inductor ls and source winding resistance r ) are studied under the conditions of different von , different ton and different winding parameters . then a conclusion can be drew , that the smaller lf and the bigger r are , the better the bias - magnetic is restrained and c has a best value to retrain the bias - magnetic
  分别对管压降不同,导通时间不同以及两原边绕组参数不一致(包括漏感、电阻、激磁电感三种情况)的情况下,主要参数(包括箝位电容c 、输出滤波电感lf 、负载r 、原边绕组漏感ls 、原边绕组电阻r )对偏磁的抑制作用进行了仿真分析研究,得出lf越小, r越大时激磁磁势偏移量ni越小, c在其他参数确定时对抑制偏磁有最优值等结论,为参数的优化设计提供了依据。