结构断面的英文

• structural section

• "结构"英文翻译    structure; composition; cons ...
• "断面"英文翻译    section; fracture surface; p ...
• "结构断裂" 英文翻译 :    structural break; structurebreaking
• "断面" 英文翻译 :    section; fracture surface; plane of fracture
• "船体横断面结构扭变应力" 英文翻译 :    racking stress
• "交叉扎绳；船体横断面结构变形" 英文翻译 :    wracking
• "断面；横断面；截面" 英文翻译 :    cross section
• "冲断面" 英文翻译 :    plane of thrust; thrust fault plane; thrust plane; thrust surface; thrust-fault plane
• "瓷断面" 英文翻译 :    porcelain fracture
• "大断面" 英文翻译 :    porrible maximum cross－section
• "单断面" 英文翻译 :    single section
• "等断面" 英文翻译 :    uniform cross section
• "断面，剖面" 英文翻译 :    profile
• "断面比" 英文翻译 :    cross-section ratio
• "断面法" 英文翻译 :    crosssectional method; method of cross－section survey; method of sections; profile method; range method; ritter's method
• "断面积" 英文翻译 :    basal area; crosssectional area; sectional area
• "断面索" 英文翻译 :    tag line
• "断面图" 英文翻译 :    cross sectional drawing; crosssection; cross-sectional drawing; profile map; profile paper; section map; sectional elevation; sectional view
• "断面线" 英文翻译 :    cross hatching line; crosshatch; section line
• "断面仪" 英文翻译 :    profiler
• "断面桩" 英文翻译 :    cross－section stake
• "阀断面" 英文翻译 :    valve area
• "副断面" 英文翻译 :    auxiliary sectional plane
• "高断面" 英文翻译 :    maximum section of passenger flow
• "沟断面" 英文翻译 :    ditch section

• - ii - 5 . with the consideration that the cross section of the cable - stayed structure and the rigid frame structure ' s are not uniform , a new joint solution was presented for these different sections
  5 、针对金马大桥斜拉桥侧主梁截面与t构侧主梁截面形式不统一的问题，提出了一种不同结构断面的新型连接方法。
• The static and dynamical parameterized finite element model of the whole frame of the pipe belt conveyor and the fluid dynamic parameterized finite element model of the structural section are established by the software ansys of the finite element analysis . and then the static wind load of the whole frame of the pipe belt conveyor is calculated through the average wind pressure theory and computer simulation technology
  利用有限元分析软件ansys建立圆管带式输送机整体机架结构的静、动力参数化有限元模型及结构断面的流体动力学参数化有限元模型,并通过平均风压理论及计算机模拟技术计算出作用于机架结构的静风荷载。
• With the construction of the west of our country developing at top speed and the need of construction of mountainous expressway , the tunnel engineering , especially the tunnels on the mountainous expressway , will be increased . if the design of support structures of the tunnel still adopts traditional design methods , it will be difficult to give full considerations for the reasonability in economy of the sections of the support structures and for the reliability of bearing capacity and stability of the support structures
  随着我国西部建设的高速发展和山区高速公路建设的需要，隧道工程特别是山区高速公路隧道工程将会日益增多，隧道支护结构的设计若仍采用传统的隧道支护结构设计方法将难以充分兼顾支护结构断面经济上的合理性和支护结构承载力与稳定性的可靠性，往往安全系数偏大，不能达到“最优设计”的目的。