直流工作的英文

• dc operation

• "直流"英文翻译    direct-current; constant cur ...
• "工作"英文翻译    work; operation; working; op ...
• "直流工作电流" 英文翻译 :    working direct current
• "直流工作电压" 英文翻译 :    dcwv direct current working volts; direct-current working voltage; direct-current working volts; volts direct-current working; working volts direct current
• "直流工作点分析" 英文翻译 :    dc operating point analysis
• "直流工作点稳定" 英文翻译 :    dc stabilization
• "单流工作" 英文翻译 :    neutral operation; single current working
• "轮流工作制" 英文翻译 :    work on rotating-basis
• "双电流工作" 英文翻译 :    double current operation
• "双流工作制" 英文翻译 :    double current working
• "交流工作电流" 英文翻译 :    working alternating current
• "交流工作电压" 英文翻译 :    working volts alternating current
• "气体镇流工作" 英文翻译 :    gas ballast operation
• "反向电流工作法" 英文翻译 :    reverse current working; reverse-current working
• "每日八小时分三班轮流工作" 英文翻译 :    work in three shifts of eight hours
• "放流工" 英文翻译 :    tapper
• "直流" 英文翻译 :    direct-current (dc); constant current; steady current; continuous current; zero-frequency current; unidirectional flow◇直流泵 [机械工程] straightway pump; 直流电机 continuous current dynamo; direct-current dynamo; direct-current machine; 直流电力机车 continuous current locomotive; d. c. electric locomotive; direct-current locomotive
• "导流工程" 英文翻译 :    diversion construction; diversion works; training works
• "道流工程" 英文翻译 :    diversion construction
• "防洪流工程" 英文翻译 :    torrent works
• "分流工具" 英文翻译 :    diverting means
• "河流工程" 英文翻译 :    river engineering
• "截流工程" 英文翻译 :    closure work
• "截流工程量" 英文翻译 :    closure quantity
• "截流工工程" 英文翻译 :    closure work

• You can post your schematic here and tell us its dc working points
  你可以贴出你的电路图，告诉我们它的直流工作点。
• Volts direct - current working
  直流工作电压
• Dc on - time 10h
  直流工作时间： 10h
• Dc on - time 5h
  直流工作时间： 5h
• Circuit - breakers for overcurrent protection for household and similar installations - circuit - breakers for a . c . and d . c . operation
  家用和类似用途电器装置过电流保护断路器.交流和直流工作的线路断路器
• The improved , suitable biased rf circuits are proposed to keep the excellent performance of the rf front - end even with low voltage power supply
  但各模块通过改进电路结构和设计合理的直流工作点，在低压下依然保持了良好的性能。
• In the design of the rf front - end , the effect of the low voltage power supply must be considered since the low voltage power supply limits the voltage swing of the circuit nodes and may affect the dc operation point , power gain and linearity of the rf front - end
  本论文实现的收发机射频前端采用了1 . 8v的电源电压，射频前端各模块的设计都考虑到了低电源电压对直流工作点、增益和线性度的影响。
• The dq equivalent circuit model of three - phase three - switch boost type power - factor - correction is proposed firstly , the completely dc steady - state analysis and ac small - signal analysis are done and the dc operation points and ac transfer functions are acquired
  3 .首次提出三相三开关boost型功率因数校正的dq等效电路模型，并对其进行了完整的直流稳态和交流小信号分析，得到直流工作点和交流传递函数。
• The presented thesis studies the gas discharge of lab6 electrodes , the paper analyses the impacts of gas press and electrodes separation on the ignition voltage and voltage drop , and makes low gas pressure , lower than 10pa , discharge switch tubes , with gas of helium and nitrogen , electrodes gaps of 5mm . the paper studies the tubes ’ discharge performances , and the impacts of discharge process on the electrodes
  分析直流工作条件下,以氩气、氮气、氦气为工作气体时,气体的压强、极间距对着火电压和管压降的影响,并制作低气压( < 10pa )下的气体放电开关管(放电气体为氮气和氦气,极间距为5mm ) ,研究其在直流和脉冲下的放电特性,以及放电过程对电极的影响。
• Large signal model of gaas mesfet is built and , in the light of advanced pspice circuit simulation programme , the circuit transient and dc operation analyse and speed performances are calculated . and also , the inserted loss and isolation are optimized by microwave circuit software touchstn of eesof company
  同时，建立了gaasmesfet器件大信号模型，用先进的pspice电路模拟程序对所设计的电路进行瞬态分析和直流工作点分析，计算电路的速度性能；用eesof公司的touchstn微波电路设计软件，进行开关的插入损耗和隔离度的优化设计。