直流偏置的英文

• dc bias
• direct current biasing

• "直流"英文翻译    direct-current; constant cur ...
• "偏置"英文翻译    polarization; skewing; offse ...
• "直流偏置法" 英文翻译 :    dc biasing
• "直流偏置调整" 英文翻译 :    dc bias set
• "电流偏置" 英文翻译 :    current bias
• "直流偏磁" 英文翻译 :    dc magnetic biasing
• "直流偏压" 英文翻译 :    dc biasing
• "直流偏压法" 英文翻译 :    direct current biasing
• "直流偏移" 英文翻译 :    dc bias direct current bias; dc offset
• "交流偏置记录" 英文翻译 :    ac-bias recording; ac□bias recording
• "直通电流偏置" 英文翻译 :    through current bias
• "去除直流偏移" 英文翻译 :    remove dc offset
• "直流偏压控制" 英文翻译 :    dc bias control
• "交流偏置录音法" 英文翻译 :    alternating current biased recording
• "偏置偏压偏流偏磁斜的加偏压……偏置……斜" 英文翻译 :    bias
• "偏置" 英文翻译 :    polarization; skewing; offset; bias; biasing; setover 偏置的任何物体都不是垂直的。 anything in a leaning position is not upright
• "直流" 英文翻译 :    direct-current (dc); constant current; steady current; continuous current; zero-frequency current; unidirectional flow◇直流泵 [机械工程] straightway pump; 直流电机 continuous current dynamo; direct-current dynamo; direct-current machine; 直流电力机车 continuous current locomotive; d. c. electric locomotive; direct-current locomotive
• "偏置位；偏差；偏置" 英文翻译 :    offset
• "分流偏滤器" 英文翻译 :    divertor
• "河流偏转" 英文翻译 :    river deflection; stream deflection
• "滑流偏转" 英文翻译 :    slipstream redirecting
• "交流偏磁" 英文翻译 :    ac bias; ac magnetic biasing; acbias; alternating current biasing; alternating current magnetic biasing
• "交流偏压" 英文翻译 :    ac bias
• "交流偏压法" 英文翻译 :    ac biasing method; alternating current biasing method
• "喷流偏度" 英文翻译 :    jet deflection

• 3 dc offset set to 0 v
  3直流偏置设置为0v
• Greatly different from previous works , the matching circuits and dc bias networks are bent many times , for minimizing the lna
  与以往同类工作有很大不同，为了实现lna小型化的目的，对匹配电路和直流偏置网络采用多次曲折线的形式。
• During the testing , there is much work to do for the purpose of improving those targets including the biasing circuit modulating . for the best result
  测试过程中,要针对上述各项指标进行电路的调整,其中包括直流偏置电路的调整,以求达到最好的效果。
• The low insertion loss is achieved by optimizing the transistor widths and bias voltages , by minimizing the substrate resistances , and by dc biasing the transmit and receive nodes , which decreases the capacitances while increasing the p1db
  通过优化mosfet的栅宽及偏置电压可以降低插入损耗。在版图设计中通过增加衬底接触降低衬底电阻,从而减小插入损耗。另外,为接收和发送端提供直流偏置可以降低p1db 。
• Classic u - i model is simple . however the integrator inevitably bring up the error accumulation and dc drift . this paper present a new integrator method . it has been proved to be a successful alternative for integrator , but in simulation it is found not fit for dtc
  定子磁链的观测是dtc的关键技术，传统的u - i模型结构简单，实用，但是由于积分器将电流检测中的直流偏置累加，而且对定子电阻的变化鲁棒性不够。
• While simulating the resonant circuits , we finished a microstrip resonance , which has high q - factor and fits to design w - band low phase noise oscillators . select beam lead hyperabrupt junction varactor and gunn die made in china as vco ’ s frequency turning component and minus resistance
  此外,文中还对w频段微带结构直流偏置网络、微带波导过渡等外围电路进行了仿真优化,设计方法和结论对毫米波微带电路设计具有通用的参考价值。
• The open - looped driving circuit is based on the idealization of the vibration . the square wave voltage and the direct current voltage are combined to drive the gyroscope . influences of square wave voltage are analyzed though simulation . as for the real situation of the vibration , the closed - looped driving circuit is given
  开环电路采用方波加直流偏置的等效交流电压驱动陀螺振动，通过模拟分析了方波驱动形式对陀螺振动的影响；结合开环驱动电路，提出了闭环驱动电路方案。
• Second , the results of theory analysis and simulation research show that the output of one cycle controlled bridge switching power amplifier have dc offset because of the nonideal characteristic of reset signal . the magnitude of output dc offset voltage is proportional to width of reset pulse . a voltage compensation technique is used to solve this question , and the computation formula of compensation voltage is gived . the circuit compensated and not are researched through simulation and experiment , which results show that compensated circuit solve the output dc offset effectively
  其次，理论分析和仿真研究结果表明，由于复位脉冲的非理想特性，单周控制的全桥开关功率放大器输出端存在直流偏置问题，其大小与复位脉冲的宽度成正比。针对输出直流偏置问题，提出了电压补偿的改进方案，给出了补偿电压的具体计算公式。对补偿前和补偿后的方案进行了对比仿真研究和实验研究。
• First , passive resistance network was selected as direct current biasing network , which offered direct voltage for base through the resistance voltage divider composed of two resistances , among them the upper resistance connected from the dc to base , the lower resistance connected from the base to ground . the collector connected with dc directly
  直流偏置网络采用无源电阻网络，通过由两个电阻组成的电阻分压器为基极提供直流电压，上偏电阻从电源串联到基极，下偏电阻从基极到地，集电极直接加电。
• These topologies of inverters are composed of two bi - boost dc / dc converters , they are symmetry . so whole circuit turn into four - quadrant converters , we can control every power mosfet on or off . then we can get sine wave with direct current polarization at the left , at the same we also can get sine wave with direct current polarization phase contrast 180 compared of the left at the right
  这类逆变器由左右二个双向boostdc / dc变换器构成,左右二边是对称的,所以整个电路构成了一个四象限变换器,我们可以恰当控制各功率管的开、关,使左边的两象限dc / dc变换器输出一个带直流偏置的正弦波,使右边的两象限dc / dc变换器输出一个相差180度带同样直流偏置的正弦波形,这样,负载zl上的电压是左、右两个dc / dc变换器电压的差动输出,正好可以消掉直流偏置,最终在负载r1上得到的就是正弦波。