电子束辐照的英文

• electro beam irradiation

• "电子束"英文翻译    electron beam
• "辐照"英文翻译    irradiation; irradiate
• "电子束辐照法" 英文翻译 :    ebap
• "低能电子束辐照" 英文翻译 :    low energy electron beam irradiation
• "电子束辐射" 英文翻译 :    electron beam irradiation
• "多光束辐照" 英文翻译 :    multibeam irradiation
• "会聚束辐照" 英文翻译 :    convergent-beam irradiation
• "宽束辐照" 英文翻译 :    broad beam irradiation; broad-beam irradiation
• "微束辐照" 英文翻译 :    micro irradiation
• "生物微束辐照" 英文翻译 :    biological microirradiation
• "电子束辐射加工装置剂量学导则" 英文翻译 :    kev25mevv
• "电子束" 英文翻译 :    electron beam; pencil; bunch of electrons; bundle of electrons; cathode beam; cathode-ray beam; cathode-ray pencil; electron bundle; electron rays; electronic beam
• "电子群, 电子束" 英文翻译 :    packet of electrons
• "电子束电子" 英文翻译 :    beam electrons
• "电子辐照" 英文翻译 :    electron irradiation
• "电子束压焊, 电子束焊" 英文翻译 :    electron beam bonding
• "保持电子束" 英文翻译 :    holding beam
• "带状电子束" 英文翻译 :    stripe electron beam
• "单电子束" 英文翻译 :    single electronic beam
• "单电子束管" 英文翻译 :    single electron beam tube
• "单能电子束" 英文翻译 :    monoenergetic electron beam; single energy electron beam
• "单速电子束" 英文翻译 :    single velocity electron beam
• "电子束（电磁波）" 英文翻译 :    electric ray rags electrico ,has electrico
• "电子束摆动" 英文翻译 :    beam jitter
• "电子束泵浦" 英文翻译 :    electrton-beam pumping

• Calculation of protection dose at the labyrinthine outlet of electron beam irradiation apparatus
  电子束辐照装置迷路出口处的防护剂量计算
• Conversion method of absorbed doses in different materials irradiated by x , rays and electron beams
  X射线和电子束辐照不同材料吸收剂量的换算方法
• In order to reduce and compensate charge phenomena at the surface of non - conductive oxide materials under the electron irradiation , oxygen environmental scanning electron microscopy ( sem ) is offered in this thesis
  本论文提出氧环境扫描电子显微分析方法，以减轻和补偿非导电氧化物类样品在电子束辐照作用下的表面充电现象。
• The mechanisms of charge and charge compensation are discussed : we suggest electron stimulated desorption ( esd ) at the surface and inner defects induced by the electron beam bombardment are main reasons of charge
  对ys - zro2样品加热到230 ，使其表面充电得到改善。本文讨论了在电子束辐照下， al2o3 、 sio2 、 ys - zro2等氧化物材料的充电机制，以及氧环境的充电补偿机制。
• The agreement is also within the uncertainty when being compared with the alanine and cta film dosimeters made by jaeri . in addition , this dosimetry system is used to measure field and depth - dose distribution curves for 12mev electron beams , which shows it ' s suitability and practicability for electron beam irradiation
  另外，还利用该剂量体系对12mev电子束辐照场的分布及深度剂量分布进行了实际测量，得到了与cta和fwt60等薄膜剂量计相一致的结果，这也进一步说明该剂量体系在电子束辐照上的适用性和实用性。
• This topic focused on the radiation effect on the uhmwpe fiber with electron beam ( eb ) radiation . and instron , sem , atr - ir , xps , epr , xrd et al were used to characterize the structure and properties of uhmwpe fiber before and after radiation treatmentand on this condition we probed into the grafting modification with eb radiation technology
  本课题研究uhmwpe纤维的电子束辐照效应，运用电子强力机、扫描电镜( sem ) 、全反射红外( atr ? ir )光谱、 x射线光电子能谱( xps ) 、电子顺磁共振仪( epr ) 、 x射线衍射仪( xrd ) 、接触角和交联度测定等方法对uhmwpe纤维在电子束辐照作用下的主要结构与性能变化规律进行了表征和分析，在此基础上对运用电子束辐照技术进行uhmwpe纤维的表面接枝改性进行了探讨。
• By means of electron beam irradiation , some oxygen containing groupe are introduced on the molecular chain of lldpe , the interface compatibility of the composite is improved . the yield strength and young ' s modulus of ramie / lldpe are increased from 9 . 78 mpa , 432 mpa to 13 . 1 mpa and 633 mpa respectively
  经电子束辐照后， lldpe分子链中引入含氧基团，苎麻电子束辐照lldpe复合材料的界面相容性提高，复合材料的屈服强度、杨氏模量从9 . 78mpa 、 432mpa提高到13 . 1mpa 、 633mpa 。
• The studies expressed that the tensile - strength declined with the growth of dose rate after the radiation treatment , and at the same time , the gel content had extreme value with the change of the dose rate . the surface of uhmwpe fibers showed some irregular micro - pits and dents after radiation treatment , narnely rough degree increasing . their number and deepness increased with increase of dose . and this phenomenon is the most obvious when the dose rate was 8 . 5kgy / s and the dose was 400kgy . at the same time some containing oxygen groups , including hydroxyl group , carbonyl group and carboxyl group , were introduced into the fiber surface which was exposed to the air
  研究表明， uhmwpe纤维经电子束辐照处理后，纤维的拉伸断裂强度随剂量率的增加呈下降趋势，凝胶含量随着剂量率的变化存在极值。纤维表面出现了不规则的微裂纹和凹痕，随着剂量的增大，电子束对纤维表面的刻蚀程度增加，在本研究中以剂量为400kgy剂量率为8 . 5kgy s时刻蚀效应最为明显。同时，在空气中进行辐照时，纤维表面被引入了一些含氧基团，包括羟基、羰基和羧基。
• The presence of microwave or ultrasonic wave , the inter - and intra - molecular complexation of cellulose molecules through hydrogen bonding is weakened , and the complexed polymer of cellulose and nylon formed in situ . the yield strength and young ' s modulus of the ramie / nylon / lldpe composites are increased from 9 . 68 mpa , 260 mpa to 15 . 7 mpa and 722 mpa respectively
  经微波辐照或超声波处理后，苎麻纤维素氢键被削弱，与尼龙形成氢键复合物，增强了苎麻尼龙电子束辐照lldpe复合材料体系的相容性，屈服强度、杨氏模量从9 . 68mpa 、 260mpa提高到15 . 7mpa 、 722mpa 。