热烟气的英文

• hot-gas

• "循环热烟气" 英文翻译 :    hot recuperation gas
• "回转窑热烟气流" 英文翻译 :    hot kiln gas flow
• "热烟" 英文翻译 :    hot smoke
• "烟气" 英文翻译 :    combustion product gases; flue gases; flue-gas; fumes; gas fume; gas-air heater; gas-to-air heater; smoke gas; smoky gas; stack gas
• "热烟草" 英文翻译 :    cured tobacco
• "热烟层" 英文翻译 :    hot layer
• "热烟道" 英文翻译 :    heating flue; hot flue
• "热烟流" 英文翻译 :    thermal plume
• "热烟区" 英文翻译 :    hot smoke zone
• "热烟羽" 英文翻译 :    thermal plume
• "废热烟道" 英文翻译 :    waste heat flue
• "清热烟道" 英文翻译 :    regenerative flue
• "热烟雾机" 英文翻译 :    thermal aerosol generators
• "热烟熏的" 英文翻译 :    hot-smoked
• "余热烟道" 英文翻译 :    waste heat flue
• "干烟气" 英文翻译 :    dry flue gas
• "铅烟气" 英文翻译 :    lead fume
• "烟气；烟雾" 英文翻译 :    fume
• "烟气侧" 英文翻译 :    fireside; gas-side
• "烟气量" 英文翻译 :    quantity of flue gas
• "烟气流" 英文翻译 :    fume flow; gaseous flux
• "烟气密" 英文翻译 :    fume tight
• "加热烟雾发生器" 英文翻译 :    thermal aerosol generator
• "不漏烟气" 英文翻译 :    smoke tight
• "热盐的" 英文翻译 :    thermohaline

• Numerical simulation of the interaction between smoke and water mist in fire
  细水雾与热烟气相互作用数值模拟研究
• After the flue heat evaporates the moisture , dry sodium or calcium salts and the un - reacted absorbent are collected in the dust collector . however , very few domestic companies have the ability to manufacture the fdg system
  ，吸收剂喷入洗涤塔时为雾化的泥浆，水汽慢慢地被热烟气所蒸发，最后以乾钠盐或钙盐及未反应的吸收剂混合物之型式，被集尘机所收集去除。
• The hight and temperature of heat smoke during the fire was obtained by using numerical simulation method , people in the bowling alley could evacuate safely was proved and the building ' s fire safety objective was satisfied
  通过数值模拟给出了发生火灾时的热烟气层温度和热烟气层高度发展过程，证实了保龄球馆的水喷淋和机械排烟系统能够保证人员安全疏散，满足消防安全要求。
• They are removed using catalytic or oxidation reactions to form non - toxic nitrogen or nitrates . practical processes include ammonia and catalytic method , high - temperature nitrogen reduction method , activated carbon and incineration as well as alkaline washing
  ，吸收剂喷入洗涤塔时为雾化的泥浆，水汽慢慢地被热烟气所蒸发，最后以乾钠盐或钙盐及未反应的吸收剂混合物之型式，被集尘机所收集去除。
• In this paper , performance - based fire safety design concept was adopted to analyze fire safety objective of a underground bowling alley should achieve , fire scenarios were designed and the performance of water sprinkler and mechanical smoke evacuation system was studied by using zone model
  摘要采用性能化防火设计的思想，分析了某地下保龄球馆火灾热烟气安全需求，设计了可能发生的火灾场景，使用区域模拟技术研究了保龄球馆水喷淋和机械排烟系统的有效性。
• Analysis result of simulation shows : underground commercial streets and atrium can use natural filling . in the actual engineering , mechanical smoke exhaust system is used by the local fire department added . the night club uses a set of mechanical smoke exhaust system , and the quantity of supply air can ’ t be less than 50 percent of the exhaust
  模拟研究表明:地下商业街和中庭可以采用自然填充,在实际工程中当地消防部门在中庭增设机械排烟系统,以加快热烟气的排放;夜总会采用机械排烟,补风量不应小于排烟量的50 % 。
• The three - wastes fluid - bed multifuel burner utilizes the characteristics of fluid - bed burning and the blow gas waste heat boiler for recovery , and burns the waste gas , ash and residue from the gasifier to produce hot flue gas , which , after dust settling in the multiple dust collector , enters the waste heat boiler to recover waste heat for the generation of high - grade steam to be used in production
  摘要三废流化床混燃炉系运用流化床燃烧特点，采用吹风气馀热锅炉回收模式，对造气产生的废渣、废灰、废气混燃，产生热烟气，经组合式除尘器除尘后，进入馀热锅炉回收馀热，生产高品质蒸汽供生产用。
• Numerical simulation by cfd was carried out to understand the hot current behavior in a tunnel with longitudinal ventilation . it becomes clear that fire source modeling is very important because the hot current behavior is strongly affected by the fire source position and is sensitive to methods in the modeling of the fire source . the flame area which has developed from the fire source is an area of chemical reaction caused by combustion . even if grids in the vicinity of the fire source are made fine , it was difficult to simulate the heat generation area with consideration to this chemical reaction through using a method for setting the heat release rate simply on the fire source surface . therefore , we proposed a method adopting the knowledge on flame shape under the longitudinal ventilation and incorporating it into numerical simulation and it showed a good agreement with the experimental results . it was shown through experiments in a tunnel with longitudinal ventilation that the hot current developed toward the tunnel center downwind from the fire source near a wall . the cause was investigated by numerical simulation and it became clear from the results that the spiral air by the fire plume created a vortex in the crevice between the wall and the plume
  运用cfd进行数字模拟,以了解纵向通风隧道内热烟气流的特性.通过模拟发现对火源进行模拟非常重要,热烟气流特性受火源位置的影响很大,并且对火源模拟方法很敏感.火源生成的火焰区是燃烧引起的化学反应区域.即使火源附近的木垛排列完好,也很难在考虑这些化学反应条件下模拟热生成区域.建议考虑纵向通风隧道内火焰形状并对它进行数字模拟.模拟结果与试验结果非常吻合.试验证明,在纵向通风隧道内,热烟气流从靠近墙体火源处顺风向隧道中心蔓延.数字模拟结果发现,火灾羽流造成的螺旋上升空气会在墙体和羽流之间形成一个涡流区
• Abstract : numerical simulation by cfd was carried out to understand the hot current behavior in a tunnel with longitudinal ventilation . it becomes clear that fire source modeling is very important because the hot current behavior is strongly affected by the fire source position and is sensitive to methods in the modeling of the fire source . the flame area which has developed from the fire source is an area of chemical reaction caused by combustion . even if grids in the vicinity of the fire source are made fine , it was difficult to simulate the heat generation area with consideration to this chemical reaction through using a method for setting the heat release rate simply on the fire source surface . therefore , we proposed a method adopting the knowledge on flame shape under the longitudinal ventilation and incorporating it into numerical simulation and it showed a good agreement with the experimental results . it was shown through experiments in a tunnel with longitudinal ventilation that the hot current developed toward the tunnel center downwind from the fire source near a wall . the cause was investigated by numerical simulation and it became clear from the results that the spiral air by the fire plume created a vortex in the crevice between the wall and the plume
  文摘:运用cfd进行数字模拟,以了解纵向通风隧道内热烟气流的特性.通过模拟发现对火源进行模拟非常重要,热烟气流特性受火源位置的影响很大,并且对火源模拟方法很敏感.火源生成的火焰区是燃烧引起的化学反应区域.即使火源附近的木垛排列完好,也很难在考虑这些化学反应条件下模拟热生成区域.建议考虑纵向通风隧道内火焰形状并对它进行数字模拟.模拟结果与试验结果非常吻合.试验证明,在纵向通风隧道内,热烟气流从靠近墙体火源处顺风向隧道中心蔓延.数字模拟结果发现,火灾羽流造成的螺旋上升空气会在墙体和羽流之间形成一个涡流区