流比的英文

• flow ratio

• "比"英文翻译    2
• "变流比" 英文翻译 :    transformer ratio
• "电流比" 英文翻译 :    current ratio
• "返流比" 英文翻译 :    reflux ratio
• "分流比" 英文翻译 :    diversion ratio; split ratio; splitting ratio
• "滑流比" 英文翻译 :    slip fraction; sliratio
• "回流比" 英文翻译 :    recirculation ratio; reflux ratio
• "流比计" 英文翻译 :    quotient meter; ratiometer
• "流比能" 英文翻译 :    specific energy of flow
• "屏流比" 英文翻译 :    bucking current ratio
• "曲流比" 英文翻译 :    meander ratio
• "蠕流比。" 英文翻译 :    creep ratio
• "入流比" 英文翻译 :    inflow ratio
• "射流比" 英文翻译 :    jet ratio
• "塑流比" 英文翻译 :    creep ratio
• "涡流比" 英文翻译 :    swirl rate
• "整流比" 英文翻译 :    commutating ratio; rectification ratio; rectifying ratio
• "变流比误差" 英文翻译 :    current ratio error
• "测电流比计" 英文翻译 :    logometer
• "低回流比" 英文翻译 :    low reflux ratio
• "电流比计" 英文翻译 :    current ratiometer; logometer
• "电流比较器" 英文翻译 :    current comparator
• "电流比较式" 英文翻译 :    current comparison system
• "电流比值差" 英文翻译 :    current error; current limiting threshold
• "高回流比" 英文翻译 :    high reflux ratio

• Multiple of cash flow per share
  每股现金流比
• Current ratio error
  变流比误差
• A centrifuge used to determine the volume of blood cells and plasma in a given sample of blood
  血球容量计，血流比容计一种离心机，用于测定所给样血中血细胞和浆细胞的容量
• The effects of operating parameters such as split ratio and feed flowrate on separation efficiency were analyzed
  并考察了油滴直径、进料流量及溢流比的变化对分离效率的影响。
• We studied the factor that influence the quality of gaas , algaas and ingaas by mbe , and studied the growth temperature , growth time and the flux ratio of v - iii beam
  研究了影响mbe生长gaas 、 algaas和ingaas等单晶材料质量的一些因素，对mbe生长温度、生长时间和生长时的-族束流比进行了研究。
• Increasing suction rate or flow reynolds number can increase pressure coefficients , but the existence of ribs lead to decrease of pressure coefficients . the higher the ribs , the lower the pressure coefficients
  出流比和雷诺数的增大都有使压力系数增大的趋势，而肋则使压力系数降低，肋高增大，压力系数降低的幅度越大。
• When there is no impingement , the investigation about flow extravasation effect form film cooling holes is carried out with different cross flow reynolds numbers and different density flow ratios of the film outflow to cross flow
  在无冲击射流时，通过改变来流雷诺数、气膜出流与横流密流比，对气膜孔的“溢流效应”进行了研究。
• Reynolds numbers ( based on average velocity at passage inlet and hydraulic diameter of the passage ) are changing from 20000 to 80000 and the extraction ratios ( suction ratios , sr ) are changing from 0 . 30 to 0 . 60 for each test model . so the influences of reynolds numbers , suction ratios and etc . on the discharge coefficients and pressure loss characterist ics are also presented . flow fields of typical passages are visualized with the flow visualization techniques and measured with hot - wire anemometer
  对每一种通道结构，实验在不同通道进口雷诺数( re = 20000 、 40000 、 60000 、 80000 )和不同通道总出流比( sr = 0 . 30 、 0 . 45 、 0 . 60 )下进行，以研究这两个流动参数及其它相应变化的参数(气膜孔的雷诺数re _ h 、气膜孔与通道的动量比i等)对出流特性和流阻特性的影响规律。
• The measurements of discharge coefficients and pressure coefficients along the models with aspect ratios of 0 . 5 , 1 . 0 and 2 . 0 were carried out under various aerodynamic and geometric parameters ( reynolds numbers : 20000 , 40000 , 60000 , 80000 ; suction rates : 0 . 3 , 0 . 45 and 0 . 6 ; rib angles : 45 , 60 , 90 , 120 ; rib height - to - width ratio h / e : 1 . 0 and 2 . 0 ; film hole location : middle of ribs . upstream of ribs and downstream of ribs ) . based on the abundant experimental data and figures , rules of discharge coefficients and pressure coefficients in dependence of geometric and aerodynamic parameters were given out
  根据实验课题的要求，在宽高比分别为1 . 0 、 2 . 0和0 . 5的内流冷却通道里，在不同的气动和几何参数(雷诺数re分别为20000 、 40000 、 60000 、 80000 ，出流比sr为0 . 3 、 0 . 45和0 . 6 ，肋角分别为45 、 60 、 90 、 120 ，肋高h e分别为1 . 0和2 . 0 ，孔位分别为肋中间、肋下游和肋上游)的情况下，对流量系数和压力系数以及流场进行了实验研究，获得了大量的实验数据和图形，较为详细地给出了流量系数和压力系数随不同气动参数和几何参数而变化的规律。
• When considering the maximum multiplier effect of the whole economic area we should take a series of measures to improve the mpc of each branch area and the investment in - flow rate of the branch area with a higher mpc as well as the investment outflow rate of the branch with a lower mpc ; also to be considered is the in - flow rate of investment capital to the branch area with a higher mpc
  当投资对整体区域的总体乘数效果成为关注的目标时，应当采取措施提高各子区域的边际消费倾向、边际消费倾向相对较高的子区域的投资内流比、边际消费倾向相对较低的子区域的投资外流比、期初投资流入边际消费倾向相对较高子区域的比例，以获得投资对整体区域总体乘数效果的最佳化目标。

• 流比什么意思：同类比照类推。    ▶ 北齐 颜之推 《颜氏家训‧文章》： “世人或有文章引《诗》‘伐鼓渊渊’者， 《宋书》已有屡游之诮；如此流比， 幸须避之。”    ▶ 《宋书‧殷琰传》： “去冬开天之始， 愚迷者多， 如足下流比， 进非社稷宗臣， 退无顾命寄托， 朝廷既不偏相嫌责， 足下亦复无所独愧。”