正常工作状态的英文

• normal operating conditions
• normal up-state
• normal working conditions

• "正常"英文翻译    normal; regular; average
• "工作状态"英文翻译    duty; functional mode; opera ...
• "正常操作条件, 正常工作状态" 英文翻译 :    normal operation condition
• "可正常工作状态；有效运转条件" 英文翻译 :    operative condition
• "正常轰炸工作状态" 英文翻译 :    normal attack bomb mode
• "正常工状态" 英文翻译 :    normal operating condition
• "不正常工作" 英文翻译 :    irregular working
• "正常工作" 英文翻译 :    normal operate; normal operation; normal work; proper functioning; regular work
• "正常工作点" 英文翻译 :    normal working point
• "正常工作日" 英文翻译 :    regular working day
• "正常工作时" 英文翻译 :    normal working hour
• "不工作状态" 英文翻译 :    non-operating state; off position; off-position
• "非工作状态" 英文翻译 :    off working state; out-of-service condition
• "工作状态" 英文翻译 :    functional mode; in-service condition; mode of operation; modes of operation; operating condition; operating duty; operating mock; operating mode; operating state; operational status; working order; working position
• "工作状态中" 英文翻译 :    i. at work
• "在工作状态" 英文翻译 :    inthegreen
• "正常工作灯头" 英文翻译 :    service lamp
• "正常工作电流" 英文翻译 :    running current
• "正常工作电压" 英文翻译 :    normal working voltage
• "正常工作方式" 英文翻译 :    normal operation mode
• "正常工作开支" 英文翻译 :    normal operating expenses
• "正常工作面积" 英文翻译 :    normal working area
• "正常工作频率" 英文翻译 :    normal working frequency
• "正常工作时间" 英文翻译 :    constant failure-rate period; good time; normal operating period; normal operation portion; normal working hours; ordinary working hour
• "正常工作条件" 英文翻译 :    nominal operating condition; normal operating conditions; normal running conditions; normal working condition; usual service conditions

• Analysis of the malfunction of nss - 20 automated high - pressure steam sterilizer and its solution
  20型全自动高压蒸气灭菌柜不能进入正常工作状态的故障分析
• Closely monitor the condition of the tachometer ; stop to deal with any problem if discovered such as words - jamming and words - jumpping , etc
  密切监视转数表工作情况，发现卡字、跳字及其它不正常工作状态时应立即停车处理。 。
• This experiment carefully observed and recorded the phenomena and the operating parameter under normal and abnormal conditions
  本实验对不同工况下，正常工作状态或异常情况下的实验现象和运行参数进行了仔细的观察和记录分析。
• Admittedly , it had been placed under extreme conditions when it failed , but such forces are to be expected from time to time when the machine is running normally
  不可否认极限条件导致失败，但在正常工作状态下，这种极限条件也会遇到的。
• In contrast , as for key inspect regions , the elastic and plastic characteristics of stru cture and its parts , even the effect being parts invalidation , should be taken into account completely as well
  对于关键监测区域，不仅研究结构的正常工作状态，还应该考虑结构和材料的非线性性质和组件失效后对于整个网架结构的影响。
• The experiment results confirmed convincingly that noises measurement method not only is feasible , but also have many advant ages , such as the similarity of detection conditions to the actual state , short test time , good sensitivity and non - destructivity
  而且与其它传统的测试方法相比，噪声方法有着测试条件接近正常工作状态、测试时间短、敏感度高和非破坏性等优点，有较好的应用前景。
• With the coal gas producer furnace as heat resource , in low temperature burning , the sulfur dioxide and dust withdrawal is lower than the national standard . therefore under normal work condition , regardless of the boiler size all may achieve the smokeless running
  采用煤气发生炉做热源，由于低温燃烧，二氧化硫及烟尘的排放量低于国家标准，因此在正常工作状态下，无论锅炉大小都可以达到无烟化运行。
• Reliability , which is the most important index to measure the stability of sg - iii , is closely related to the system shot success ratio , maintenance and support costs . it indicates the ability of sg - iii to keep working or to perform its required function
  可靠性作为神光iii装置稳定运行的最重要的衡量指标,直接关系到其打靶成功率、运行维修和保障费用,表征了装置在使用过程中保持正常工作状态或完成规定任务的能力。