校准法的英文

发音:

"校准法"怎么读用"校准法"造句

英文翻译手机版

calibrating method
calibration method

"校准"英文翻译 calibration; correct; align; ...
"法"英文翻译 law
"编队校准法" 英文翻译 : formation method of caliraton
"二级校准法" 英文翻译 : secondary calibration method
"互易校准法" 英文翻译 : reciprocity calibration
"内部校准法" 英文翻译 : internal calibration
"拖锥校准法" 英文翻译 : trailing cone calibration method
"一级校准法" 英文翻译 : primary calibration method
"标准飞机校准法" 英文翻译 : pacer aircraft calibration method
"标准加入校准法" 英文翻译 : standard addition calibrating technique
"飞过塔台校准法" 英文翻译 : tower fly-by calibration method
"可追踪式校准法" 英文翻译 : calibration, traceable; traceable calibration
"摄影机空中校准法" 英文翻译 : in flight camera calibration method
"无液气压计校准法" 英文翻译 : aneroid method of calibration
"静压系统雷达跟踪校准法" 英文翻译 : radar tracking calibration method
"校准" 英文翻译 : [机械工程] calibration; correct; align; aline; graduation true-up; standardizing; adjusting 方位校准 bearing calibration; 校准工 truer; 校准精度 calibration accuracy; 校准器 calibrator; etalon; regulator; truer; 校准装置 calibrating equipment
"标准法" 英文翻译 : harmonization of standards; standard law
"视准法" 英文翻译 : collimation method; collimationmethod
"背侧基准法" 英文翻译 : back side reference method
"比较标准法" 英文翻译 : comparison method with standard
"标准法兰" 英文翻译 : sexless flange; standard flange
"标准法律" 英文翻译 : model law
"标准法税" 英文翻译 : duty in the sliding scale
"不准法码" 英文翻译 : false weights
"成绩基准法" 英文翻译 : point of average response

例句与用法

Free calibration by self - calibrate in gas sensor system
用双路自校准法实现气敏传感器的长期稳定工作
In - flight camera calibration method
摄影机空中校准法
Standard test method for trace impurities in monocyclic aromatic hydrocarbons by gas chromatography and external calibration
用气相色谱法和外部校准法对单环芳香烃中微量杂质的标准试验方法
Plastics - determination of average molecular mass and molecular mass distribution of polymers using size - exclusion chromatography - universal calibration method
塑料.用粒度排除色谱法测定聚合物的平均分子量和分子量的分布.通用校准法
The method using square wave excitation presented by the paper is verified by theories and experiments that the method meets the requirement of accuracy , and this method ' s application simplifies manipulations and improve greatly the calibration efficiency
其中本文提出的方波信号激励的比较校准法，理论和实验证明不仅满足校准精度要求，而且简化操作，大大提高了校准的效率。
Lastly , the minimum permission reliability index is offered by the method of " calibration method " which makes back calculation out of the bending resistance reliability and the compression resistance reliability of the reinforced concrete member in norm
最后，根据“校准法”反演计算现行设计规范中钢筋混凝土结构抗弯、抗压可靠度指标以确定在用桥梁结构体系的最低目标可靠度指标。
Secondly , precipitation from the radar estimating precipitation model ( rep ) are verified using a rain - gage network of 127 stations in order to show the effects of five methods : zi , optimal interpolation joint of optimal interpolation and kalman filter , kalman filter , and average method . the results show that the method of optimal interpolation and the method of joint have the lowest rms errors and the method of zi has the highest rms errors
结果表明：将地面雨量计值作为真值，则联合校准法和最优插值校准法得出的降水量计算精度最高，卡尔曼滤波校准法和平均校准法的计算精度低于联合校准法和最优插值校准法， zi关系法的精度最低。
The multi - port measurement system has the widespread use in microwave measurement , the measurement of multi - port device with two - port vector network analyzer ( vna ) is researched . this paper analyzes the commonly used error models and calibration methods of vna , program a trl calibration procedure for two - port vna , and compare the tested data with the data from vna . the comparison show that the programmed trl calibration procedure is in the same accuracy as the vna
本文讨论了两端口矢量网络分析仪常用的误差模型和校准方法,编制了两端口矢量网络分析仪基于trl校准法的校准程序,并把校准后的测量结果和矢量网络分析仪校准后的测量数据做了比较,比较结果说明编制的trl校准程序校准效果和矢量网络分析仪校准的效果相同。
Last , the reliability of 50kg / m - rail and 60kg / m - rail is calculated by using the method combing the mote - carlo imitation with the finite element method . on the basis of the calibration method , the objective reliability index of the steel rail is recommended , and the problems of the present standards of the rail - wear limits are pointed out , and then the rail - wear limits are discussed
最后，采用有限单元法与蒙特卡罗法相结合的方法对50kg m轨和60kg m轨的可靠度进行了计算，根据“校准法”的思想得到了钢轨目标可靠指标的建议值，指出了现行钢轨磨耗标准所存在的问题。