时效状态的英文

• aged condition

• "时效"英文翻译    effectiveness for a given pe ...
• "状态"英文翻译    status; state; condition; st ...
• "人工时效状态" 英文翻译 :    artificially aged condition
• "应变时效状态" 英文翻译 :    strain age hardness
• "等效状态" 英文翻译 :    equivalent state
• "失效状态" 英文翻译 :    failed state; failure state
• "无效状态" 英文翻译 :    null state
• "有效状态" 英文翻译 :    effective status; significant condition; valid state
• "有效状态数" 英文翻译 :    number of significant conditions
• "彻底失效状态, 完全失效状态" 英文翻译 :    total failure mode
• "处于高效状态" 英文翻译 :    at concert pitch
• "有效状态主码" 英文翻译 :    efficient state descriptors
• "后管路失效状态" 英文翻译 :    rear tube failure
• "前管路失效状态" 英文翻译 :    front tube failure
• "已标示段落的有效状态" 英文翻译 :    effective status of a marked section
• "有效状态［条件］， 显效条件， 显著性条件" 英文翻译 :    significant condition
• "时效" 英文翻译 :    1.(在一定时间内能起的作用)effectiveness for a given period of time2.[法律] prescription3.[冶金学] ageing; aging◇时效规则 limitation rules; 时效期限 length of limitation period; limitation period; 时效中断 interruption; interruption of prescription; 时效中止 cease to run (of limitation period); 时效终止 lapse of time
• "有效状况" 英文翻译 :    traffic condition
• "技术绩效状况" 英文翻译 :    technical performance status
• "磁时效" 英文翻译 :    magnetic aging
• "过时效" 英文翻译 :    overageing; overaging
• "老化；时效" 英文翻译 :    aging
• "冷时效" 英文翻译 :    cold ageing
• "热时效" 英文翻译 :    heat ageing; heat aging; thermal ageing; thermal aging
• "时效，成熟" 英文翻译 :    ageing，aging

• The results indicated that , the fabrication process of ultra - fine grain material is mainly determined by the stress , rotate speed and the flux of cooling water . the grain refining and the hardening effect are mostly affected by the rotate speed and the flux of cooling water . compared with commercial ly12 , the invalidate strength and the prolongation rate of the ultra - fine grain material are properly improved in the measurement of compression property ; and the abrupt change of the dilatability of the ultra - fine grain material at 500c is found ; also the phenomena of which the grain size of these microstructures is stable when annealed under 300c is observed
  研究表明，采用本文提出的摩擦压扭强变形区转移法可以得到棒状的超细晶材料，轴向压力、扭转速度和温度是采用该方法制备超细晶材料的主控参数；试件的旋转转速和冷却速度对变形区晶粒细化和硬化效果影响显著；超细晶ly12的压缩性能与淬火+自然时效状态的ly12压缩性能相比，断裂强度和延伸率均有一定程度的增强；超细晶ly12的热膨胀系数在550左右发生明显的变化。