断裂载荷的英文

发音:

"断裂载荷"怎么读用"断裂载荷"造句

英文翻译手机版

break load
breaking load
crippling load
crushing load
fracture load
fracturing load

"断裂"英文翻译 break; disrupt; flying-off; ...
"载荷"英文翻译 load; loading
"钩接断裂载荷" 英文翻译 : loop breaking load
"极限断裂载荷" 英文翻译 : ultimate breaking load
"结节断裂载荷" 英文翻译 : knot breaking
"平均断裂载荷" 英文翻译 : mean fracture load
"主动断裂载荷" 英文翻译 : active breaking load; activebreaking load
"最大断裂载荷" 英文翻译 : maximum breaking load
"断裂载重" 英文翻译 : breaking load
"开裂载荷" 英文翻译 : cracking load
"破裂载荷" 英文翻译 : crack load
"碎裂载荷" 英文翻译 : crushing load
"压裂载荷" 英文翻译 : crushing load
"断裂" 英文翻译 : break; disrupt; flying-off; fracture; fragmentation; out-break; rift;crack;bursting;rupture;rending; tearing; segmentation◇断裂标志 signs of failure; 断裂长度 breaking length; 断裂次数 breaks; 断裂带 [地质学] riftzone; fault zone; fracture zone
"分裂载波制" 英文翻译 : split carrier system
"开裂载重" 英文翻译 : load at first crack
"载荷" 英文翻译 : load; loading◇载荷变化 load fluctuation; variation in load; 载荷装置 load device
"dna断裂" 英文翻译 : dna breakage
"大断裂" 英文翻译 : major dislocation
"单断裂" 英文翻译 : single break
"地断裂" 英文翻译 : geofracture; geosuture
"断口；断裂" 英文翻译 : fracture
"断裂，破坏" 英文翻译 : breakdown
"断裂；破裂" 英文翻译 : fracture
"断裂槽" 英文翻译 : rupture groove

例句与用法

Steel wire ropes . method for determination of breaking load
钢丝绳.断裂载荷的测定方法
Stranded steel wire ropes - specification for higher breaking load ropes
绞股钢丝绳.第8部分:高断裂载荷钢丝绳规范
Natural stone test methods - determination of the breaking load at a dowel hole
天然石料试验方法.榫钉孔处断裂载荷的测定
Active breaking load
主动断裂载荷
Fishing nets . determination of breaking load and knot breaking load of netting yarns
鱼网.网线的断裂载荷和结头断裂载荷的测定方法
Natural stone test methods - determination of the breaking load at dowel hole ; german version en 13364 : 2001
天然石料试验方法.榫钉孔断裂载荷测定
Alpine skis - determination of deformation load and breaking load ; identical with iso 6265 : 1992
高山雪撬.变形载荷和断裂载荷的测定;等同采用iso 6
Cross - country skis . determination of breaking load and deflection at break with quasistatic load
速度滑雪板.准静态载荷断裂条件下断裂载荷和偏差的测定
The method for measuring the plane strain fracture toughness klc has been introduce to high polymer bonded explosives ( pbx ) by systematically studying technologies concerning the shape of specimen , the depth and its machining of crack , the loading rate , the measurement of critical fracture load , and the computation of klc , etc . the method has been used to test and study klc of three typical high polymer bonded explosives which are j2 , jl , j3 respectively both at normal temperature and unmoral temperature
本文以高聚物粘结炸药为研究对象，对测试高聚物粘结炸药的平面应变断裂韧度所涉及的样品形状、裂纹深度及裂纹制备、加载速度、临界断裂载荷p _ q的确定及平面应变断裂韧度k _ ( ic )的计算等方面进行深入研究，建立了较为完善的炸药平面应变断裂韧度测试方法。
Aiming at the simulation of quasi - brittle fracture of concrete - like materials , the qualitative comparison of the selected models was focused on the follow aspects , i . e . the simulation of the fracture behaviors of crack mode and crack mode by use of the selected models and the simulation of dilatancy properties of the selected models under mixed - mode fracture loading conditions
在对选择的典型黏性界面裂纹进行定性分析比较时着重考虑以下两点：采用选择的模型对型裂纹和型裂纹的断裂行为进行数值计算；对混合型断裂载荷作用下模型的扩容行为特性进行数值分析。