径向压力的英文

• radial compression
• radial pressure
• radial roll pressure
• radial unit roll pressure

• "径向"英文翻译    radial; radial direction
• "压力"英文翻译    pressure; tension
• "径向压力表" 英文翻译 :    (pressure)gauge with bottom connection; gauge with bottom connection
• "径向压缩" 英文翻译 :    radial compression
• "径向压缩机" 英文翻译 :    radial compressor
• "径向压缩柱" 英文翻译 :    radically compressed column
• "径向压应力" 英文翻译 :    radial compression stress; radial compressive stress
• "横向压力；侧向压力" 英文翻译 :    lateral pressure
• "径向压溃强度" 英文翻译 :    radial crushing strength
• "径向压溃载荷" 英文翻译 :    radial crushing load
• "径向压密系数" 英文翻译 :    coefficient of consolidation for radil flow cr; coefficient of consolidation for radil flow,cr
• "径向压缩试验" 英文翻译 :    diametral cmpression test
• "径向压缩应力" 英文翻译 :    radial compressive stress
• "侧向压力" 英文翻译 :    lateral compressive force; lateral pressure; thrust
• "层向压力" 英文翻译 :    edgewise pressure
• "单向压力" 英文翻译 :    uniaxial pressure; unidirectional pressure
• "导向压力" 英文翻译 :    pilot pressure
• "定向压力" 英文翻译 :    direct pressure; direct(directed)pressure; directed pressure; directional pressure; directive pressure
• "法向压力" 英文翻译 :    normal pressure
• "法向压力角" 英文翻译 :    normal pressure angle
• "法向压力解" 英文翻译 :    normal pressure angle
• "反向压力" 英文翻译 :    backpressure; reversed compression; uplift pre ure; uplift pressure; upward pressure
• "方向压力" 英文翻译 :    directional pressure
• "负向压力波" 英文翻译 :    negative pressure wave
• "横向压力" 英文翻译 :    lateral pressure; transverse pressure

• Post - buckling of a functionally graded circular plate subjected to radial compression
  径向压力作用下功能梯度圆板的过屈曲
• Based on the classical nonlinear plate theory , axisymmetric post - buckling behavior of a functionally graded circular plate under radial compression was investigated
  摘要基于经典非线性板理论，研究了功能梯度圆板在均匀的径向压力作用下的轴对称过屈曲问题。
• Abstract : the present paper analyzes the axial pressure of the coil , the working principle of the coil drum and causes of slide scar on the strip head and advances the new method for the taper control of the coiling tension
  文摘:针对单机架平整机的带钢头部滑伤问题，分析了钢卷径向压力、卷筒的工作原理，及带钢头部滑伤形成原因，提出了卷取张力采用锥形控制的新方法。
• For the construction of single - arch tunnel within cracked surrounding rocks , 8 tunnel models are set up to study the effect of the earth pressure distribution of the various surrounding rocks due to excavation . the relationships between the loosen zone of tunnel radial earth pressure and the tunnel diameter , the characteristics of surrounding rocks and the exposed time are revealed . it is showed that the pressure loosen radius is 1 . 2 ~ 2 . 0 tunnel diameters and the strongly loosen radius drops to 0 . 5 ~ 1 . 0 one for double lane tunnel
  对于单拱破碎围岩隧道的构筑问题，作者设置了8个隧道模型，研究开挖对不同隧道围岩压力分布的影响，揭示了洞周径向压力的松弛范围与洞径、围岩特性、裸露时间的关系，得到双车道隧道压力松弛半径为1 . 2 2 . 0倍洞径，强烈松弛区半径为0 . 5 1 . 0倍洞径。
• A two component design consisting of appropriate size and length of structural reinforcing rods and dead - end component is required to transfer axial tensile loads and distribute radial compressive forces through the plastic jacket and onto the internal strength members without damaging the fragile plastic jacket or internal optical fibers
  螺旋预绞丝结构不仅能有效地降低配合区域内光缆单位应力和避免应力集中，传递轴向张力，而且将预绞丝的径向压力均匀地分布在这段较长的配合区域内。
• For simulating the radial static pressure gradient behind the true turbine guide cascade in low speed wind tunnel with annular cascade , the backboards were placed in the downstream field of the guide model cascade of the low - pressure stage of a turbine , and the effects of the types and positions of the backboards on the outlet flow field of the model cascade were experimentally researched
  为在环形叶栅低速风洞实验中模拟实际涡轮级静叶后径向压力梯度，在某型涡轮低压级静叶的下游流场设置了挡板，实验研究了挡板形式及设置位置对静叶出口流场的影响。