实测温度的英文

• measured temperature
• observed temperature

• "温度"英文翻译    temperature
• "实测温度梯度" 英文翻译 :    measured temperature gradient
• "色测温度 色温度" 英文翻译 :    colortemperature
• "电测温度表" 英文翻译 :    electric thermometer; electrical thermometer; electrical wind vane and anemometer
• "电测温度计" 英文翻译 :    electric moisture meter; electric thermometer; electropyrometer
• "电测温度什" 英文翻译 :    electrothermometer
• "观测温度" 英文翻译 :    observed temperature
• "可测温度" 英文翻译 :    observable temperature
• "色测温度" 英文翻译 :    temperature color
• "摇测温度计" 英文翻译 :    telethermometer
• "遥测温度表" 英文翻译 :    disstance thermometer; distant-reading thermometer; remote thermometer; telethermometer
• "遥测温度计" 英文翻译 :    distance thermograph; distance thermometer; distance thermometre; distant reading thermometer; distant reading thermometre; distant thermometer; distant thermometre; remote reading thermometer; remote thermometer; telethermoeter; telethermograph; telethermometer; telethermoscope; telthermometer
• "遥测温度器" 英文翻译 :    telethermoscope
• "远测温度计" 英文翻译 :    distance thermometre; telethermometer
• "遥测温度计 遥测温度器" 英文翻译 :    telethermoscope
• "遥测温度计；遥测温度计记录" 英文翻译 :    telethermograph
• "温度计的，测温的" 英文翻译 :    thermometric
• "遥测温度探头" 英文翻译 :    telethermometer probe
• "测温锥相当温度" 英文翻译 :    cone equivalent
• "常规观测温度计" 英文翻译 :    routine observation thermometer
• "电气遥测温度表" 英文翻译 :    electric telethermometer
• "冷却遥测温度计" 英文翻译 :    colling telethermometer
• "最小可测温度差" 英文翻译 :    mdtd
• "最小可检测温度" 英文翻译 :    minimum detectable temperature
• "实测" 英文翻译 :    actual measurement; observation

• Then , the model of house is set up with system identification method after the model has been analyzed in theory
  根据所建立的数学模型对阶跃响应的仿真结果和实测温度进行比较，从中可以选择所需精度的数学模型。
• By ansys , we can build temperature - calculating modes of p . c box girder t and then calculate the effect of temperature fields on the stress and the line deformation . 3 . adopt the spot - measure method
  2 、用ansys建立预应力混凝土箱梁t构的温度计算模型，由实测温度给定边界条件，分别计算出温度对预应力混凝土箱梁t构挠度的影响以及对预应力混凝土箱梁截面应力的影响。
• As practical engineering examples the poper has shown the analyses oncrack control in two mass concrete structures by use of the procedure mentionedabove , in which the transient temperature fields were obtained from the results bythe finite difference method or the temperature curves measured in construction
  作为实例，本文采用实测温度曲线求得瞬态温度场，按上述步骤对北京地区两个大厦基础进行了抗裂分析，结果与实际情况相符，未发现裂缝。
• The problem of monitoring the wear - line of a blast furnace is treated as the inverse problem of the static heat conduction system , and the latter has been turned into the optimization of the squared residual of the measured and calculated temperature at the sensor locations
  摘要把确定高炉炉缸炉底热侵蚀边界归结为稳态热传导方程的反问题，并转化为极小化在若干测温点处由设定侵蚀边界对应的偏微分方程边值问题求得的温度与实测温度之间误差的优化问题。
• As practical engineering examples the paper has shown the analyses on crack control in two mass concrete structures by use of the procedure mentioned above , in which the transient temperature fields were obtained from the results by the finite difference method or the temperature curves measured in construction
  作为实例，本文采用有限差分法及实测温度曲线求得瞬态温度场，按上述步骤对宁波地区两个大厦基础进行了抗裂分析，结果与实际情况相符，未发现裂缝。
• On some reasonable assumptions , the existence and the uniqueness of the solution of partial differential equation are proved by using the semigroup theory ; then based on the current basin temperature from the practical survey , the mathematical model about the identification problem is established , and the identifiability and the existence of the optimal solution of the identification problem are proved ; in terms of the adjoint method presented by chavent , the optimality condition of the identification problem is given ; finally the corresponding algorithm is devised
  在适当的假设条件下，利用算子半群方法证明古地温度场方程解的存在惟一性；根据现今实测温度，建立了问题的参数识别模型；证明了可识别性、最优解的存在性；利用chavent等人提出的伴随方法，给出参数识别问题最优解存在的最优性条件和求该参数识别问题的算法。