发射与接收的英文

• tr transmit and receiving

• "发射"英文翻译    launch; radiate; project; di ...
• "与"英文翻译    take part in; participate in
• "接收"英文翻译    receive; reception; accept; ...
• "射频发射与接收" 英文翻译 :    rftr radio frequency transmit and receive
• "无线射频发射与接收" 英文翻译 :    rftr radio frequency transmit and receive
• "移动无线电发射与接收" 英文翻译 :    mrtr mobile radio transmit and receive
• "发送与接收" 英文翻译 :    transmit and receive
• "传送与接收控制器" 英文翻译 :    trc transmission and reception controller
• "发送器与接收器" 英文翻译 :    transmitter and receiver
• "导弹发射与储存工事" 英文翻译 :    launcher-and-missile storage structure
• "发射与无线电设备的特性" 英文翻译 :    charateristics of emissions and radio equipment
• "播送与接收控制设备" 英文翻译 :    trc transmission and receive control equipment
• "发送器与接收器的时钟" 英文翻译 :    the clocks at the transmitter and receiver
• "跨频段的发送与接收" 英文翻译 :    cross band operation
• "跨频率的发送与接收" 英文翻译 :    crossband operation
• "无线电的传播与接收" 英文翻译 :    transmission and reception of radio waves
• "震源数与接收器数的乘积" 英文翻译 :    source-receiver product
• "发射-接收开关" 英文翻译 :    transmit-receive switch
• "发射接收管" 英文翻译 :    transmit-receive tube
• "发射接收机" 英文翻译 :    transmitter receiver; transreceiver
• "发射接收天线" 英文翻译 :    transmit receive antenna
• "声发射接收器" 英文翻译 :    sound emission microphone
• "让步条件下不合格产品的放弃与接收" 英文翻译 :    release or acceptance of nonconforming product under concession
• "对讲机,发射接收机" 英文翻译 :    transmitter receiver
• "接收和发射设备" 英文翻译 :    receiving and transmitting equipment

• Transmission and reception controller
  发射与接收控制器
• It is an important support of smart antenna directional transmitting and receiving technology
  它是智能天线指向性发射与接收的重要的技术基础。
• Repairing the integrated circuit of the controlling emitting and receiving ultrasound wave in hitachi eub - 26 ultrasound b system
  超超声发射与接收控制电路修理三法
• Also the emitting and receiving circuit was designed , and the emitting and receiving delay of each unit was controlled by computer
  设计了发射和接收电路，通过计算机控制实现探头各晶片阵元的延迟发射与接收。
• The hardware mainly consists of three parts : signal pre - amplifying and conditioning circuit is used to amplifying the microseismic signals which have detected , signal processing and target identifying circuit based on singlechip is used to convert the analog signals which have been amplified to digital signals and go through signal analysis , processing to identify the moving target , the sending and receiving setting is used to send the identifying result to the decision - making and he can take relevant action according to the result
  硬件主要由三部分组成：信号调理电路对检测到的微弱地震动信号进行放大；基于单片机的信号分析与目标识别电路将放大后的模拟信号进行a d转换，进一步将得出的数字信号分析、处理，实现目标识别；识别结果发射与接收装置将识别结果发射给决策者，由其根据接收结果采取相应的措施。
• With the established rf front - end system simulation platform , adding the digital modulated baseband signal , this paper simulated the multifold digital modulated signal ’ s transmission , such as 2ask , qpsk , and 16qam . then researches of power compression and phase noise of local oscillation influence the bit error ratio for different modulated system . the designing is satisfied multifold functions request with the high - powered and integrated broadband rf front - end
  随后在建立的宽带射频前端通用仿真平台上,加入基带数字调制信号,对多种数字调制格式的信号在该通用平台上的传输作了研究,模拟了2ask 、 qpsk和16qam等调制格式信号的发射与接收,研究了功率压缩和本振相位噪声对不同调制的误码率影响,实现了满足多种功能要求的宽带高性能综合射频前端的设计。