压损的英文

• damage due to pressing
• damaged due to pressing
• damaged owing to crushing
• loss of pressure

• "压"英文翻译    press; push down; hold down; ...
• "损"英文翻译    decrease; lose
• "净压损" 英文翻译 :    net pressure loss
• "变压损失" 英文翻译 :    transformation loss
• "承压损坏" 英文翻译 :    bearing failure
• "电压损耗" 英文翻译 :    voltage loss
• "电压损失" 英文翻译 :    loss of voltage; voltage loss
• "动压损失" 英文翻译 :    dynamic pressure loss; momentum pressure loss
• "风压损失, 漏气" 英文翻译 :    air loss
• "静压损失" 英文翻译 :    static pressure loss
• "内压损害" 英文翻译 :    internal pressure damage
• "气压损伤" 英文翻译 :    barotrauma
• "全压损失" 英文翻译 :    pitot loss
• "受到压损" 英文翻译 :    damaged owing to crushing
• "受压损坏" 英文翻译 :    fail in compression
• "水压损失" 英文翻译 :    head loss
• "压损系数" 英文翻译 :    pressure loss coefficient
• "液压损失" 英文翻译 :    hydraulic loss; hydraulic slip; hydraulic-pressure loss
• "予压损失" 英文翻译 :    preload loss
• "总压损失" 英文翻译 :    pitot loss
• "板碳电压损失" 英文翻译 :    plate to carbon voltage loss
• "鼻窦气压损伤" 英文翻译 :    sinus barotrauma
• "环空泵压损失" 英文翻译 :    annular pressure loss; anti-burning mechanical draft cooling tower
• "母线电压损失" 英文翻译 :    bus voltage loss
• "为他货碰压损" 英文翻译 :    contact with other cargo

• Large capacity , small system pressure loss
  处理能量大，系统压损小。
• Study on pressure drop of two phase flow in positive pneumatic conveying system
  面粉正压气力输送的两相流压损研究
• Collecting effect for dust particles . 2 . utilize the high pressure instant injection to shake down
  应用高压瞬间喷射，可将粉尘震落而达到压损固定，风量变动小，及
• It is important not only to know the maximum flow capacity of a valve but also to know how capacity varies over the valve stroke
  控制阀流量模拟分析技术主要利用数值模拟分析计算控制阀的流量、压损、入口静压与阀开度的关系。
• Through static emulating calculation of the high - pressure heater , the influence of high - pressure heater leakage upon its operation paeameters , such as outlet temperature of the feed - water , pressure loss of the steam extraction pipeline , and temperature of the drain , has been analysed
  摘要通过对高压加热器的静态仿真计算，分析了高压加热器?漏对其运行参数，如给水出口温度、抽汽管道压损、疏水温度的影响。
• By citing distribution piping loss curve , analyses the two commonly used control methods of constant pump head and constant remote circuit differential pressure and considers that control with a constant remote circuit differential pressure is the better
  通过提出输配管压损曲线概念，从理论上分析了计量供热变流量系统循环水泵常用的恒扬程控制和恒定最不利环路压降控制两种方案，认为恒定最不利用户资用压力方案节能效果较好。
• It not only can keep small change of blast volume and highly dust - collecting efficiency but also can allow to complete service and maintenance for replacement of cartridge without entering the inside of dust collector . the dust collector has been applied to plastic industry , metal treatment industry , electric welding industry , electronic industry , wood working industry , cement industry , etc . and has got favorable responses from the customers
  滤管式集尘机系应用高压瞬间喷射原理而将粉尘震落可达到压损固定，风量变动小及保持高效率之集尘外，更换滤管时，工作人员可以不必进入集尘机内，即可完成维修及保养工作。
• The results of this part of the study show that the supersonic separator has a satisfactory dehydration performance without any need of external mechanical power and chemicals . the influences of pressure loss ratio on its dehydration performance were also studied . it is well indicated by the results that the pressure loss ratio is a key factor that determines the dehydration performance of the supersonic separator , increasing pressure loss ratio usually improves its separation performance
  如果要获得较低的干气出口露点或较大的露点降,那么必须以牺牲一部分初始压力作为代价;保持超音速分离管入口流量为临界流量是保证超音速分离管具有良好气液分离性能的必要条件;压损比、激波产生的位置是影响超音速分离管工作性能的关键。
• Moreover , compared with the channel with no hole baffle , the channel with hole ' s baffle , because the change of structure of the baffle , flow resistance reduced , the drop of flow pressure reduced as follow , the d / w , sl / w and s2 / w also influenced the channel ' s heat transfer
  并且，对于设置开孔折流板的通道，相对于设置未开孔折流板通道来说，由于折流板表面的变化，减小了流体流过时的阻力，进而降低了流体流动压损，无量纲孔径d w 、无量纲水平中心距s1 w和无量纲垂直中心距s2 w等多个参数对通道换热均有一定的影响。