功率控制器的英文

• power controller

• "功率"英文翻译    power; rate of work; capacit ...
• "控制器"英文翻译    controller; regulator; monit ...
• "线性功率控制器" 英文翻译 :    lpc linear power controller
• "比率控制器" 英文翻译 :    ratio controller
• "频率控制器" 英文翻译 :    frequency controller
• "速率控制器" 英文翻译 :    rate controller; speed controller
• "功率控制" 英文翻译 :    pc power control; powcontrol; powercontrol
• "功率控制棒" 英文翻译 :    power control rod
• "传输功率控制" 英文翻译 :    tpc transmission power control
• "发射功率控制" 英文翻译 :    tpc transmit power control; transmit power control
• "发送功率控制" 英文翻译 :    tpc transmit power control
• "反向功率控制" 英文翻译 :    rpc: reverse power control
• "峰值功率控制" 英文翻译 :    peak power control
• "功率控制单元" 英文翻译 :    pcu power control unit
• "功率控制电路" 英文翻译 :    power control circuit
• "功率控制电平" 英文翻译 :    power control level
• "功率控制前缀" 英文翻译 :    pcpower control preamble
• "功率控制系数" 英文翻译 :    power control ratio
• "功率控制元件" 英文翻译 :    power control member
• "功率控制装置" 英文翻译 :    pcu power control unit
• "基站功率控制" 英文翻译 :    bs power control
• "激光功率控制" 英文翻译 :    laser power control
• "进近功率控制" 英文翻译 :    apc approach power control
• "脉动功率控制" 英文翻译 :    pulsating power control
• "平均功率控制" 英文翻译 :    average power control

• Specification for hybrid remote power controllers - general requirements
  混合式遥控功率控制器规范.一般要求
• Specification for solid - state remote power controllers - general requirements
  固态遥控功率控制器规范.一般要求
• Abstract : in this paper , we describe the design and function , application of the power unit controller for mini rf excited co2 laser , pulse width modulation ( pwm ) is the convenient way to vary the laser average output power from 1 % to 100 % of maximum
  文摘:述了小型rf激励co2激光器的功率控制器设计、功能和应用，根据脉宽调制原理可以方便地把激光功率从1 %变化到100 % 。
• So the equipment is schemed out to simulate the work - state of aepds , according to the in - out signals of every solid - state power controller ( sspc ) and the stochastic voltage and current of buses . the top - down design method is adopted in the design
  所以作者根据固态功率控制器输入、输出信号仿真多路负载，以及汇流条的电压、电流等在飞机配电系统中的各种工作状况，研制了“先进飞机配电终端自动测试装置” 。
• In software development , distribution , priority , task flow chart design , parallel schedule of tasks are discussed in detail . finally , elmc model is finished and tested with power system processor ( psp ) , solid state power controller ( sspc ) , and servo system
  文中详细分析了任务划分、任务优先级分配、各任务流程图设计及任务间的并行工作方式等；设计完成了elmc原理样机，并与供电处理机、固态功率控制器和伺服控制系统进行联合调试。
• Procreant knowledge expression and forward inference engine are adopted in the method of fault diagnosis based on expert system theory . in the fault diagnosis applying neural network theory , six kinds of improved arithmetic of back - propagation arithmetic , including gradient descent with momentum , variable learning rate back - propagation , resilient back - propagation , quasi - newton , levenberg - marquardt and conjugate gradient , are applied to diagnose the faults of electric load manage center and solid state power controller . different diagnostic results gotten by simulation are compared at last
  在基于专家系统的故障诊断方法中，采用了产生式知识表达和正向推理机制；在基于神经网络的故障诊断方法中，则分别采用了bp神经网络的附加动量法、自适应学习速率、弹性bp算法、拟牛顿法、共轭梯度法和levenberg - marquardt法对电气负载管理中心和固态功率控制器的故障进行诊断，并对由仿真得到的不同诊断结果进行比较。
• Digital inputs are processed by fpga after being isolated by photocouplers . the results of digital inputs saved in fpga are read by tms320lf2407 periodically . the digital outputs being written to fpga are used to control empcs after being isolated by photocouplers and driven by darlington transistors
  由于数字量的路数较多，因此采用了fpga进行扩展和简单处理，数字量输入通过光电隔离后送给fpga进行软件滤波，其结果由tms320lf2407定时读取； tms320lf2407输出的数字量先送给fpga ，再由fpga经过光电隔离和功率驱动后去控制机电式功率控制器。
• The fault diagnosis software of power supply system applying the expert system theory is programmed under vb 6 . 0 . while the fault diagnosis of electric load manage center and solid state power controller is based on the neural network theory , whose software is realized through adopting the neural network toolbox of matlab 6 . 1 in vb 6 . 0
  对于飞机供电系统，在vb6 . 0中编写了基于专家系统理论的故障诊断软件；对于电气负载管理中心和固态功率控制器，其故障诊断软件则基于神经网络理论，通过在vb6 . 0中调用matlab6 . 1的神经网络工具箱完成。