入口流量的英文

• inlet flow rate

• "入口"英文翻译    enter the mouth
• "流量"英文翻译    rate of flow; flow; runoff; ...
• "汽机入口流量" 英文翻译 :    throttle-flow
• "计量的入口流量" 英文翻译 :    metered inlet flow
• "入口流" 英文翻译 :    entry flow; incoming flow; influent
• "炉入口流体" 英文翻译 :    furnace inlet stream
• "入口流动" 英文翻译 :    flow at mouth
• "出口流量" 英文翻译 :    outlet discharge; rate of discharge
• "进口流量" 英文翻译 :    inlet flow rate
• "孔口流量" 英文翻译 :    orifice meter
• "孔口流量计" 英文翻译 :    orifice flow meter; orifice gage; orifice gas flow meter; orifice meter; orifice metre; orificemeter
• "入口流动效应" 英文翻译 :    entry flow effect
• "入口流式回路" 英文翻译 :    meter in circuit
• "凹口流量系数" 英文翻译 :    discharge coefficient for notch
• "变孔口流量计" 英文翻译 :    variable aperture flow meter; variable-aperture flowmeter
• "出口流量函数" 英文翻译 :    export flow function
• "端口流量控制" 英文翻译 :    port flow control
• "进口流量曲线" 英文翻译 :    entrance discharge curve
• "井口流量控制" 英文翻译 :    wellhead flow control
• "孔口流量系数" 英文翻译 :    orifice metering coefficient; orifice-metering coefficient
• "计量的出口流量" 英文翻译 :    metered outlet flow
• "主动脉瓣口流量" 英文翻译 :    aortic valve flow
• "入口实际体积流量" 英文翻译 :    inlet actual volumetric flow
• "活塞冷却油出口流量低报警" 英文翻译 :    piston cooling oil outlet low flow alarm
• "活塞冷却油出口流量低降速" 英文翻译 :    piston cooling oil outlet low flow slow-down

• The theoretical analysis and the simulation of the chain structure model indicate that the fluctuations of mass leaving enthalpy close in on that of distributed parameter model with two - order , two - order , and three order precision at the disturbances of heat flow rate , mass entering flow rate , and mass entering enthalpy
  理论分析及仿真结果表明，该模型在热流量、入口流量和入口焓的扰动条件下，出口焓的变化分别以二阶、二阶、三阶精度逼近分布参数模型。
• The results of this part of the study show that the supersonic separator has a satisfactory dehydration performance without any need of external mechanical power and chemicals . the influences of pressure loss ratio on its dehydration performance were also studied . it is well indicated by the results that the pressure loss ratio is a key factor that determines the dehydration performance of the supersonic separator , increasing pressure loss ratio usually improves its separation performance
  如果要获得较低的干气出口露点或较大的露点降,那么必须以牺牲一部分初始压力作为代价;保持超音速分离管入口流量为临界流量是保证超音速分离管具有良好气液分离性能的必要条件;压损比、激波产生的位置是影响超音速分离管工作性能的关键。