turbogenerator造句

• A nonlinear unified controller design for heavy - duty turbogenerator
  大型汽轮发电机非线性综合控制器设计
• Methods and limits for checking the direct gas ventilation cooling system of turbogenerator rotor
  透平发电机转子气体内冷通风道检验方法及限值
• Application of fuzzy clustering theory for diagnosing the vibration faults of turbogenerator units
  聚类模糊原理在汽轮发电机组振动故障中的应用
• The osilating monitoring and diagnosis system by using turbogenerator unit is introduced
  摘要介绍了借助汽轮发电机组进行振动监测和故障诊断的系统。
• Application of fuzzy clustering analysis for the diagnosis of vibration faults of turbogenerator units
  模糊聚类分析在汽轮发电机组振动故障诊断中的应用
• Investigation on knowledge data discovery and data mining based on the real time turbogenerator ' s monitoring data
  基于汽轮机运行监测数据的知识发现和数据挖掘初探
• Fault diagnosis of the vibration of turbogenerator units based on ga neural network and evidence theory fusion
  基于遗传神经网络和证据理论融合的水电机组振动故障诊断研究
• Measurement of airborne noise emitted by machines ; enveloping surface method ; turbogenerator sets for use in thermal power stations
  机器空气噪声的测量.包络面法.热电站用的涡轮发电机
• 2 ) the program is fit for different turbogenerators . so it can be used for a wide range . 3 ) the block structure is used in the program
  4 .研究开发了适用不同型号汽轮发电机的可就不同稳态问题进行计算研究的有限元软件。
• This paper expounds the structural design and operating mode of the sealing oil system of a turbogenerator with a detailed description of its simulation - based mathematical model set up for the system
  描述了汽轮发电机密封油系统的结构及其操作方式，并重点建立了该系统的仿真数学模型。
• Past but discuss the turbogenerators a shafting problem , describe two kinds of characteristics that lose the steady pattern with judge the method and then become the contents of thesis chapter 5
  故而探讨汽轮发电机组轴系稳定性问题，描述两种失稳型式的特征和判断方法就成为论文第五章的内容。
• Turbogenerators a type , characteristic , judgement method for familiarly vibrating fault , is a key place that thesis want to discuss , chapter 6 will join together a detailed proceeding introduction
  汽轮发电机组常见振动故障的类型、特征、判断方法，是论文要讨论的关键所在，第六章将结合实例详细进行介绍。
• Turbogenerators is an important equipment for electric power producing , because of structural complexity in its equipment and special circumstance in its running , cause the fault rate high , the harm is big
  汽轮发电机组是电力生产的重要设备，由于其设备结构的复杂性和运行环境的特殊性，导致故障率高、危害性大。
• Turbogenerators a science for familiarly vibrating fault diagnosis and electric power producing actual contact closely , having can right away converting into productivity value , and also is urgent request to producing practice
  汽轮发电机组常见振动故障诊断与电力生产实际联系紧密，具有可马上转化为生产力的学术价值，也是生产实际的迫切要求。
• At the same time , the multi - dimension knowledge representation model is built by the analysis of the konwledge principle in synthetic diagnosis system . a synthetic diagnosis system architecture is constructed for turbogenerator at last
  通过研究综合诊断系统的知识机理，建立了多维综合知识表达处理模型，最后设计了汽轮发电机组综合诊断系统结构。
• With the development of electric power , the problem of vibration on turbogenerator shafts stands out . a deep research on vibration mechanism is carried out . and valid method for preventing and diagnosing fault is explored
  随着电力工业的发展，汽轮发电机组振动问题越来越突出，人们对相应的振动机理开展了深入的研究，并积极探寻有效的故障预防和诊断方法。
• To the turbogenerators for familiarly vibrating fault proceeding diagnosis , first wanting proceeding vibration testing , this will begging not only wanting acquainting with test with principle , method and outline , and fulfillment experience controlling certainly
  对机组常见振动故障进行诊断，首先要进行振动测试，这就要求不但要熟悉测试的原理、方法和要点，而且要掌握一定的实践经验。
• On the grounds of theory of asynchronized turbogenerator ( astg ) , based on the practice of the analog asynchronized generator , this dissertation designs and debugs the computer - controlled system , and investigates detailedly the intelligent excitation control method
  本文以异步化汽轮发电机（ astg ）理论为依据，模拟试验机组的实践为基础，设计并调试了计算机测控系统，并对异步化汽轮发电机的励磁智能控制方法作了深入的研究。
• Aimed at the rotor bearing system of 300 mw steam turbogenerator set and on the basis of establishing its concentrated general model with 8 supportings and 9 nodes , a study was carried out on the bending vibration response of the most left end surface of shafting and of the right end face of generator
  摘要针对300mw汽轮机组转子轴承系统，在建立其8支承9节点集总模型的基础上，对轴系最左端面和发电机右端面的弯曲振动响应进行研究。
• For solving the existing problems of machine braking and electrical braking during the process of stoppage of a turbogenerator set , a magnetic reducing method is recommended , which can greatly reduce the current of generators at switch due to remainder magnetic and abate the demand for braking switch
  摘要针对水轮发电机组在停机过程中，目前广泛采用的机械制动和常规的电气制动中所存在的问题，提出了采用减磁法来进行水轮机发电机组的电气制动。