汇接交换机的英文

• tandem switching exchange
• ts tandom switch

• "汇"英文翻译    converge
• "换"英文翻译    exchange; barter; trade
• "机"英文翻译    machine; engine
• "数字汇接交换机" 英文翻译 :    digital tandem exchange
• "汇接交换局" 英文翻译 :    tandem exchange
• "转接交换机" 英文翻译 :    transit exchange
• "汇接交换局（机）" 英文翻译 :    tandem exchange
• "汇接交换系统" 英文翻译 :    tandem switching system
• "电子式汇接交换" 英文翻译 :    electronic tandem switching
• "长途转接交换机" 英文翻译 :    toll transit switch
• "城市间转接交换机" 英文翻译 :    intercity transit exchange
• "国内转接交换机" 英文翻译 :    national transit exchange
• "交叉连接交换机" 英文翻译 :    crossconnect switch
• "市内转接交换机" 英文翻译 :    intracity transit exchange
• "公共信道转接交换机" 英文翻译 :    common channel transit exchange
• "汇接交叉" 英文翻译 :    junction transposition
• "汇接用纵横制自动电话交换机" 英文翻译 :    concourse-connection longitudinal-transverse auto-telephone exchange
• "间接交换" 英文翻译 :    indirect exchange
• "邻接交换局" 英文翻译 :    adjacent exchange
• "直接交换" 英文翻译 :    direct exchange; through switching
• "转接交换" 英文翻译 :    transit switching
• "转接交换台" 英文翻译 :    transfer board; transfer switchboard
• "交换机" 英文翻译 :    [讯] exchange board; switchboard◇交换机插塞 switch-plug; 交换机灯 switchboard lamp; 交换机电缆 switchboard cable; 交换机故障 exchange fault
• "互换，交换；交换机" 英文翻译 :    interchange
• "交换，交换机" 英文翻译 :    exchange

• On the one hand , we can use tandem switches in pairs and let them share traffic loads
  一方面，将汇接交换机成对使用，利用汇接交换机本身进行负荷分担。
• Owing to the thick line bundle between tandem switches , 126 2 mbs trunk circuits are needed
  由于汇接交换机之间的线束比较大，需要126条2mbits中继电路。
• The tandem switch is directly connected to 10 g transmission equipment via two 155 mbs coaxial cables , saving adm41 or adm161 equipment
  汇接交换机直接与10g传输设备经过2条155mbits的同轴电缆进行连接，节省了adm41或adm161设备的使用。
• With the 2 mbits trunk , a full - capacity 128 k tandem switch needs 45 shelves while with the 155 mbits trunk , it only needs 21 shelves
  一个128k的满容量的汇接交换机，如采用2mbits中继，需要４ ５个机架，采用155mbits中继，只需２ １个机架。
• As a result , at all these connection points , the two coaxial cables are connected to different transmission equipment , sharing the traffic load from the tandem switch to a given end exchange , with half of the respective trunk circuits put into use , ensuring network safety . for such connectivity , see figure 4
  因此，在所有的同轴电缆连接处，都采用两条同轴电缆接到不同的传输设备的方法，将汇接交换机到某一端局的话务量在这两条同轴连接上进行负荷分担，中继电路各开一半，从而保证网络的安全性。
• The tandem switch must first be connected to the transmission equipment providing 2 mbs ports and to the transmission equipment in other tandem area via high - speed ( e . g . 10 gbs ) transmission equipment , and then to digital access and cross - connect system ( dacs ) . it is further connected to the corresponding sdh sub - ring after the vc - 12 level cross - connection carried out by the dacs and finally reaches the end exchange
  汇接交换机首先需要连接到提供2mbs端口的传输设备，而后经高速率的传输设备（如10gbs ）到达其它汇接区的传输设备上，再接入到交叉连接设备（ dacs ）上，经dacs进行vc - 12级别的交叉连接，接到各个相应的sdh子环中，最终到达端局交换机。