内漏的英文

• inleakage
• internal hemorrhage due to trauma

• "内"英文翻译    inner; inside; within
• "漏"英文翻译    leak; drip
• "放射性内漏" 英文翻译 :    inleakage of radioactivity
• "空气内漏" 英文翻译 :    inleakage of air
• "内漏模板" 英文翻译 :    internal stripping plate
• "内隆" 英文翻译 :    noerlund; norlund
• "内卢" 英文翻译 :    nellu; nelu
• "内窿" 英文翻译 :    basinal lake; basinallake; inflow lake; inflowlake
• "内卢采斯库" 英文翻译 :    nelutescu
• "内笼" 英文翻译 :    uchikago
• "内卢卢" 英文翻译 :    nelulu
• "内龙海峡" 英文翻译 :    nerong selat; selat nerong
• "内卢兹" 英文翻译 :    nelluz
• "内龙骨与肋板连接的短角钢" 英文翻译 :    keelson lug

• 1 . wear - proof and innerleak - proof sheathed the rmocouple
  2防内漏耐磨铠装热电偶
• Summary of leakage disposal of high pressure vertical fire tube boiler without shutting - down the plant
  高压锅炉内漏时合成氨装置连续运行小结
• Valves leakage result in economy and society loss surprising . the method for detecting valves inner leakage is less and un - effectively
  由于阀门泄漏造成的经济和社会损失是十分惊人，而针对阀门内漏的检测手段较少且效果较差。
• The mathematics model is based on the relation of sources characteristic parameters and leakage rate in order to estimate leakage rate
  研究不同类型阀门内漏声源特征参量与阀门泄漏率的关系，建立阀门泄漏率定量评价的数学模型。
• Abstract : in this paper , the reasons for internal leakage of hydro - motor as driving component of antenna base for airborne radar are analyzed , and their structures are correspondingly improved
  文摘:本文针对某机载雷达天线座驱动元件液压马达的内漏进行分析，并对结构作相应改进。
• It is important that acoustic test is applied to valve leakage testing and evaluation . quadrupole sources come from leaking gap . dipole sources occur in complex structure valves through analyzing leak in valves
  通过对承压阀门内漏过程分析表明，在阀门湍流流场中，因为有泄漏缝隙的存在，必将产生四极子声。
• It makes the application , maintenance and replacing of valves scientific and the valves management more normally . moreover , it could estimate valve leakage rate on basis of the analysis of testing data
  该软件不仅能够实现石油、石化企业阀门使用、维护和更换的科学化和规范化，而且通过对阀门内漏声学检测数据的分析，实现对阀门泄漏率的定量评价。
• Best test regions are confirmed to found the acoustic emission test method for valve leakage . the large amount of data collected also allowed a brief investigation of the effects of different opening , valve types , differential pressure and leakage rates
  根据本次研究工作的目的和特点并结合现场的实际情况，探讨了内漏时阀门开度、阀门类型、两侧压差以及泄漏率等因素变化时的声学特性。
• It is proved that the improved structure has overcome original weakness of structure leakage uneven , raised the qualification rate of products , improved the technology of motor components , decreased the manufacturing cost , and will be more suitable for repetitive manufacture
  试验证明改进后的结构克服了原结构内漏不均匀的弱点，提高了成品的合格率，改善了马达零件的工艺性，降低了加工成本，更利于批量生产。
• In the whole system , the inner leak system is occurred to the lower pressure bypass system , this will directly cause the high quality reheated steam to reach to condenser , meanwhile increase the heat load of condenser , and the economy benefit of the unit will decreased
  整个系统存在的内漏主要是低压旁路低压旁路的泄漏,直接造成了高品质的再热蒸汽短路到凝汽器,同时增加了凝汽器的热负荷,对机组经济性的影响较大。