允许尺寸偏差的英文

• allowable dime ion variation
• allowable dimension ariation
• allowable dimension variation

• "允许"英文翻译    permit; allow; enable; allow ...
• "尺寸"英文翻译    measurement; dimensions; siz ...
• "偏差"英文翻译    deviation; offset; deflectio ...
• "尺寸偏差" 英文翻译 :    dimension tolterance; dimensional deviation; dimensional discrepancy; dimensional errors; dimensional variation; off size; size deviation; variation of machining size
• "尺寸允许偏差" 英文翻译 :    permissible variation in dimension
• "尺寸偏" 英文翻译 :    dimension/size is a little bigger
• "尺寸偏大" 英文翻译 :    dimension/size is a little bigger
• "尺寸偏大(小)" 英文翻译 :    dime ion/sizeisalittlebigger; dimension/size is a little bigger/smaller
• "尺寸偏斜" 英文翻译 :    off square
• "容许尺寸误差" 英文翻译 :    permissible dimensional error
• "最大容许尺寸" 英文翻译 :    upper limit
• "最小容许尺寸" 英文翻译 :    minimum admissible dimension
• "带材的尺寸允许偏差" 英文翻译 :    wrought aluminium and aluminium alloy sheets and strips-tolerances on form and dimensions
• "割缝尺寸偏小" 英文翻译 :    slot undersizing
• "铝及铝合金管材外形尺寸及允许偏差" 英文翻译 :    wrought aluminium and aluminium alloy tubes--dimensions and deviations; wrought aluminium and aluminium alloy tubes-dimensions and deviations
• "允许的偏差" 英文翻译 :    deflection allowed
• "允许偏差" 英文翻译 :    acceptable deviations; allowable deviation; allowable variation; deviation permit; permissible error; permissible variation
• "允许上偏差" 英文翻译 :    upper variation of tolerance
• "尺寸上偏差" 英文翻译 :    allowance above nominal size; over allowance
• "尺寸下偏差" 英文翻译 :    allowance below nominal size; under allowance
• "偏差，尺寸差，偏向" 英文翻译 :    deviation
• "预定允许偏差" 英文翻译 :    pre-established allowable deviation
• "最大允许偏差" 英文翻译 :    maximum allowable offset; maximumallowableoffset
• "尺寸下偏差 下差" 英文翻译 :    allowancebelownominalsize
• "尺寸允许公差" 英文翻译 :    measurement allowance

• Permissible deviation in dimensions without tolerance indication for gas cut steel plates
  气割钢板未标注公差的允许尺寸偏差

• 允许尺寸偏差的日语：きょようげんどすんぽう