The test points distributed under logarithm and linear law , and divided into 4 annulus , 16 points 截面内测试点布置按对数线性规律,分4环, 16点。
Double side probe plates : test pads can bespread on both sides of pcb for convenient pcb layout 上下针板结构:测试点可双面选点,方便电路板布线设计。
At each test point , readings are taken and compared with the laboratory standards , in constant temperature baths 每个测试点的读数将被记下,并于恒温槽内与本所的标准进行对比。
Seven test points enable a check of the output voltages and currents , by supplying proportional voltages relative to gnd 七个测试点通过对地的比例电压能够间接测量出输出的电压和电流。
Calibration is usually commenced at the lowest test temperature and the chosen test points are calibrated sequentially 校正工作通常由最低的测试温度开始,并顺序对被选定的测试点进行校正。
Calibration of a single range dc insulation resistance tester for one output voltage ( normally not exceeding 5 test points ) 按一输出电压,校正一台单量程的直流绝缘阻值测试表(通常不会超过五个测试点) 。
The probe is of very high impedance near the insulation resistance of the printed circuit material and is loading the test point with only 2 pf 80 at 1 ghz 接近印制电路板材料的绝缘电阻,并且在测试点仅载入
In this paper two steps search method is creatively presented to quickly locate the position of measurement points in numerical model 提出了两级试验测试点位置搜寻方法,分两级快速精确地确定试验测试点所在单元。
Care should be taken regarding the orientation of the test points to give sufficient room for manometer probe connection for flow measurement 要注意测试点的方位要留够足够的空间,以便连接用于水流测量的压力计探头。
The differential pressure across the pressure test points is measured and the flow rate calculated using the calibrated chart or flow coefficient table 测量经过压力测试点的压差,并利用标准化图表或流量系数表计算流动速率。