快速以太网

• Unlike atm and fddi , fast ethernet can take advantage of category 3 twisted - pair wiring found in many older ethernet installations
  与atm和fddi不一样，快速以太网可以利用在许多已安装的大型以太网上使用的3类双绞布线。
• After all , a well - installed gigabit ethernet connection will perform at least seven times better than a standard fast ethernet connection
  毕竟，一个好的千兆以太网连接的速度至少是一个标准的快速以太网连接速度的七倍。
• In addition , this paper explicated the hardware system and software system , which supported network management of the fast ethernet switcher
  另外，论文还详细介绍了实现快速以太网交换机网络管理的软件系统和硬件系统。
• Shared fast ethernet is effectively about 58m bit / sec when you consider collisions and overhead , whereas fddi is effectively 95 % utilization
  当考虑碰撞和开销时，共享式快速以太网有效地达到58兆位/秒，而fddi有效利用率达95 % 。
• Second , this essay analyses several common used net designs technologies at present and the cause of using switchong ethernet to design this system
  其次，本文分析了目前常用的几种网络设计技术，以及采用交换式快速以太网作为本系统的网络设计方案的原因。
• If you have a switched 10m bit / sec ethernet environment , you ' ve eliminated a collision domain , do with shared fast ethernet , you ' ll still have collisions
  你若有10兆位/秒的交换式以太网环境，你就消除了碰撞问题，而使用共享式快速以太网做事，你仍要遇到碰撞问题。
• Traditionally , servers are connected to networks through a nic that plugs into the server bus and supports a particular network media , such as fast ethernet or atm
  传统上，服务器通过插入服务器总线、支持某种特定网络介质（如快速以太网或atm ）的网卡连接到网络上。
• Switched fast ethernet , which provides a dedicated 100m bit / sec pipe , will increase net performance over ethernet by a factor of 10 while eliminating network collisions
  提供专用的100兆位/秒线路的交换式快速以太网将在以太网上把网络性能提高10倍，同时消除了网络碰撞。
• 2 . research the application of 100m ethernet in substation automation system , and provide a new network configuration of substation automation system base on 100m ethernet
  2 .研究快速以太网在变电站自动化系统中的应用，提出了基于100m以太网的变电站通信网的网络结构。
• Also , fast ethernet is hampered by distance limitations : its copper interfaces only support distances of 100 meters between an end - station and a repeater , and 10 meters between repeaters
  同时，快速以太网也受距离的限制：铜线接口只支持终端站与中继器之间100米、中继器之间10米。